ath9k: Enable MIB and TIM interrupts for station mode.
PATCH v2 1/1 ath9k: Enable MIB and TIM interrupts for station mode.
Enable operating mode specific interrupts in ath9k_add_interface instead of ath9k_start.
Signed-off-by Vivek Natarajan <[email protected]>
--- drivers/net/wireless/ath9k/main.c | 40 +++++++++++++++++++----------------- 1 files changed, 21 insertions(+), 19 deletions(-)
drivers/net/wireless/ath9k/main.c +21 -19
@@ -1957,25 +1957,6 @@ static int ath9k_start(struct ieee80211_hw *hw)if (sc->sc_ah->ah_caps.hw_caps &ATH9K_HW_CAP_HT ) sc->sc_imask |=ATH9K_INT_CST ; -/* -* Enable MIB interrupts when there are hardware phy counters. -* Note we only do this (at the moment) for station mode. -*/ -if (ath9k_hw_phycounters (sc->sc_ah) && - ((sc->sc_ah->ah_opmode ==NL80211_IFTYPE_STATION ) || - (sc->sc_ah->ah_opmode ==NL80211_IFTYPE_ADHOC ))) - sc->sc_imask |=ATH9K_INT_MIB ; -/* -* Some hardware processes the TIM IE and fires an -* interrupt when the TIM bit is set. For hardware -* that does, if not overridden by configuration, -* enable the TIM interrupt when operating as station. -*/ -if ((sc->sc_ah->ah_caps.hw_caps &ATH9K_HW_CAP_ENHANCEDPM ) && - (sc->sc_ah->ah_opmode ==NL80211_IFTYPE_STATION ) && - !sc->sc_config.swBeaconProcess) - sc->sc_imask |=ATH9K_INT_TIM ; -ath_cache_conf_rate (sc, &hw->conf); sc->sc_flags &= ~SC_OP_INVALID ;
@@ -2124,6 +2105,27 @@ static int ath9k_add_interface(struct ieee80211_hw *hw,/* Set the device opmode */ sc->sc_ah->ah_opmode = ic_opmode; +/* +* Enable MIB interrupts when there are hardware phy counters. +* Note we only do this (at the moment) for station mode. +*/ +if (ath9k_hw_phycounters (sc->sc_ah) && + ((conf->type ==NL80211_IFTYPE_STATION ) || + (conf->type ==NL80211_IFTYPE_ADHOC ))) + sc->sc_imask |=ATH9K_INT_MIB ; +/* +* Some hardware processes the TIM IE and fires an +* interrupt when the TIM bit is set. For hardware +* that does, if not overridden by configuration, +* enable the TIM interrupt when operating as station. +*/ +if ((sc->sc_ah->ah_caps.hw_caps &ATH9K_HW_CAP_ENHANCEDPM ) && + (conf->type ==NL80211_IFTYPE_STATION ) && + !sc->sc_config.swBeaconProcess) + sc->sc_imask |=ATH9K_INT_TIM ; + +ath9k_hw_set_interrupts (sc->sc_ah, sc->sc_imask); +if (conf->type ==NL80211_IFTYPE_AP ) {/* TODO: is this a suitable place to start ANI for AP mode? */ /* Start ANI */
Signature · 1 line
1.6.0.1