Skip to contentSkip to conversation

s2io: Formatting log message

PATCH Applied Breno Leitao 2 participants 2 messages Feb 3, 2009

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 s2io: Formatting log message

S2IO driver is printing dev->name before the name being allocated, which display eth%d instead of eth0, eth1, etc. Example:

eth%d: Enabling MSIX failed
eth%d: MSI-X requested but failed to enable

This patch just change eth%d to s2io.

---

drivers/net/s2io.c +2 -3
index f5c57c0..a63a496 100644
@@ -3862,7 +3862,7 @@ static int s2io_enable_msi_x(struct s2io_nic *nic)
 	ret = pci_enable_msix(nic->pdev, nic->entries, nic->num_entries);
 	/* We fail init if error or we get less vectors than min required */
 	if (ret) {
-		DBG_PRINT(ERR_DBG, "%s: Enabling MSIX failed\n", nic->dev->name);
+		DBG_PRINT(ERR_DBG, "s2io: Enabling MSI-X failed\n");
 		kfree(nic->entries);
 		nic->mac_control.stats_info->sw_stat.mem_freed
 			+= (nic->num_entries * sizeof(struct msix_entry));
@@ -8009,8 +8009,7 @@ s2io_init_nic(struct pci_dev *pdev, const struct pci_device_id *pre)
 		if (ret) {
 
 			DBG_PRINT(ERR_DBG,
-			  "%s: MSI-X requested but failed to enable\n",
-			  dev->name);
+			  "s2io: MSI-X requested but failed to enable\n");
 			sp->config.intr_type = INTA;
 		}
 	}
maintainer Applied
#1 lore raw

From: Breno Leitao <[email protected]>
Date: Tue, 03 Feb 2009 10:39:35 -0200

Quoted 9 lines

S2IO driver is printing dev->name before the name being allocated, which display eth%d instead of eth0, eth1, etc. Example:

eth%d: Enabling MSIX failed
eth%d: MSI-X requested but failed to enable

This patch just change eth%d to s2io.

Applied, thanks.