Status open patches: Blackfin
Dear Mike,
I have the following patches still marked as open in my list. Could you please have a look...
BlackFin:
02/19 Mike Frysinger [U-Boot] [PATCH] Blackfin: disable syscontrol code for now
02/19 Mike Frysinger Re: [U-Boot] [PATCH] Blackfin: bf537-stamp: fix I2C board defines
Thanks in advance.
Best regards,
Wolfgang Denk
Signature · 5 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de The human mind ordinarily operates at only ten percent of its capacity. The rest is overhead for the operating system.
Quoted 7 lines · On Saturday 21 February 2009 19:00:30 Wolfgang Denk wrote:
I have the following patches still marked as open in my list. Could you please have a look...
BlackFin:
02/19 Mike Frysinger [U-Boot] [PATCH] Blackfin: disable syscontrol code
for now 02/19 Mike Frysinger Re: [U-Boot] [PATCH] Blackfin:
bf537-stamp: fix I2C board defines
they're sitting in my Blackfin tree if you want to pull them from there. i just rebased against master.
-mike
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 835 bytes
Desc: This is a digitally signed message part.
Url : http://lists.denx.de/pipermail/u-boot/attachments/20090221/1b402f73/attachment.pgp
Dear Mike Frysinger,
Quoted 5 lines · In message <[email protected]> you wrote:
Quoted 3 lines · On Saturday 21 February 2009 19:00:30 Wolfgang Denk wrote:
I have the following patches still marked as open in my list. Could you please have a look...
Quoted 7 lines
Quoted 4 lines
BlackFin:
02/19 Mike Frysinger [U-Boot] [PATCH] Blackfin: disable syscontrol code
for now 02/19 Mike Frysinger Re: [U-Boot] [PATCH] Blackfin:
bf537-stamp: fix I2C board definesthey're sitting in my Blackfin tree if you want to pull them from there. i just rebased against master.
Done, thanks.
Best regards,
Wolfgang Denk
Signature · 4 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de On a clear disk you can seek forever.