Skip to contentSkip to conversation

sh: hibernation support V2

PATCH In review Magnus Damm 2 participants 2 messages Mar 6, 2009 – Mar 10, 2009

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 sh: hibernation support V2

From: Magnus Damm <[email protected]>

Add Suspend-to-disk / swsusp / CONFIG_HIBERNATION support to the SuperH architecture V2.

To suspend, use "swapon /dev/sda2; echo disk > /sys/power/state" To resume, pass "resume=/dev/sda2" on the kernel command line.

The patch "pm: rework includes, remove arch ifdefs V2" is needed to allow the generic swsusp code to build properly.

Hibernation is not enabled with this patch though, a patch setting ARCH_HIBERNATION_POSSIBLE will be submitted later.

---

V2 contains changes according to feedback from Paul.

 arch/sh/include/asm/sections.h  |    1 
 arch/sh/include/asm/suspend.h   |   13 +++
 arch/sh/kernel/Makefile_32      |    1 
 arch/sh/kernel/asm-offsets.c    |    8 ++
 arch/sh/kernel/cpu/sh3/Makefile |    2 
 arch/sh/kernel/cpu/sh3/entry.S  |   22 ++++-
 arch/sh/kernel/cpu/sh3/swsusp.S |  147 +++++++++++++++++++++++++++++++++++++++
 arch/sh/kernel/cpu/sh4/Makefile |    1 
 arch/sh/kernel/swsusp.c         |   38 ++++++++++
 9 files changed, 228 insertions(+), 5 deletions(-)
arch/sh/include/asm/sections.h +1 -0
@@ -3,6 +3,7 @@
 
 #include <asm-generic/sections.h>
 
+extern void __nosave_begin, __nosave_end;
 extern long __machvec_start, __machvec_end;
 extern char __uncached_start, __uncached_end;
 extern char _ebss[];
arch/sh/include/asm/suspend.h new file +13 -0
@@ -0,0 +1,13 @@
+#ifndef _ASM_SH_SUSPEND_H
+#define _ASM_SH_SUSPEND_H
+
+static inline int arch_prepare_suspend(void) { return 0; }
+
+#include <asm/ptrace.h>
+
+struct swsusp_arch_regs {
+	struct pt_regs user_regs;
+	unsigned long bank1_regs[8];
+};
+
+#endif /* _ASM_SH_SUSPEND_H */
arch/sh/kernel/Makefile_32 +1 -0
@@ -30,5 +30,6 @@ obj-$(CONFIG_KPROBES)		+= kprobes.o
 obj-$(CONFIG_GENERIC_GPIO)	+= gpio.o
 obj-$(CONFIG_DYNAMIC_FTRACE)	+= ftrace.o
 obj-$(CONFIG_DUMP_CODE)		+= disassemble.o
+obj-$(CONFIG_HIBERNATION)	+= swsusp.o
 
 EXTRA_CFLAGS += -Werror
arch/sh/kernel/asm-offsets.c +8 -0
@@ -12,8 +12,10 @@
 #include <linux/types.h>
 #include <linux/mm.h>
 #include <linux/kbuild.h>
+#include <linux/suspend.h>
 
 #include <asm/thread_info.h>
+#include <asm/suspend.h>
 
 int main(void)
 {
@@ -25,5 +27,11 @@ int main(void)
 	DEFINE(TI_PRE_COUNT,	offsetof(struct thread_info, preempt_count));
 	DEFINE(TI_RESTART_BLOCK,offsetof(struct thread_info, restart_block));
 
+#ifdef CONFIG_HIBERNATION
+	DEFINE(PBE_ADDRESS, offsetof(struct pbe, address));
+	DEFINE(PBE_ORIG_ADDRESS, offsetof(struct pbe, orig_address));
+	DEFINE(PBE_NEXT, offsetof(struct pbe, next));
+	DEFINE(SWSUSP_ARCH_REGS_SIZE, sizeof(struct swsusp_arch_regs));
+#endif
 	return 0;
 }
arch/sh/kernel/cpu/sh3/Makefile +2 -0
@@ -4,6 +4,8 @@
 
 obj-y	:= ex.o probe.o entry.o setup-sh3.o
 
+obj-$(CONFIG_HIBERNATION)		+= swsusp.o
+
 # CPU subtype setup
 obj-$(CONFIG_CPU_SUBTYPE_SH7705)	+= setup-sh7705.o
 obj-$(CONFIG_CPU_SUBTYPE_SH7706)	+= setup-sh770x.o
arch/sh/kernel/cpu/sh3/entry.S +17 -5
@@ -216,7 +216,7 @@ ENTRY(sh_bios_handler)
 ! r9 trashed
 ! BL=0 on entry, on exit BL=1 (depending on r8).
 
-restore_regs:
+ENTRY(restore_regs)
 	mov.l	@r15+, r0
 	mov.l	@r15+, r1
 	mov.l	@r15+, r2
@@ -362,8 +362,10 @@ general_exception:
 	 nop
 
 	! Save registers / Switch to bank 0
+	mov.l	k4, k2		! keep vector in k2
+	mov.l	1f, k4		! SR bits to clear in k4
 	bsr	save_regs	! needs original pr value in k3
-	 mov	k4, k2		! keep vector in k2
+	 nop
 
 	bra	handle_exception_special
 	 nop
@@ -471,6 +473,7 @@ handle_exception:
 
 	! Save registers / Switch to bank 0
 	mov.l	5f, k2		! vector register address
+	mov.l	1f, k4		! SR bits to clear in k4
 	bsr	save_regs	! needs original pr value in k3
 	 mov.l	@k2, k2		! read out vector and keep in k2
 
@@ -495,10 +498,10 @@ handle_exception_special:
 ! k0 contains original stack pointer*
 ! k1 trashed
 ! k3 passes original pr*
-! k4 trashed
+! k4 passes SR bitmask
 ! BL=1 on entry, on exit BL=0.
 
-save_regs:
+ENTRY(save_regs)
 	mov	#-1, r1
 	mov.l	k1, @-r15	! set TRA (default: -1)
 	sts.l	macl, @-r15
@@ -518,8 +521,16 @@ save_regs:
 	mov.l	r8, @-r15
 
 	mov.l	0f, k3		! SR bits to set in k3
-	mov.l	1f, k4		! SR bits to clear in k4
 
+	! fall-through
+
+! save_low_regs()
+! - modify SR for bank switch
+! - save r7, r6, r5, r4, r3, r2, r1, r0 on the stack
+! k3 passes bits to set in SR
+! k4 passes bits to clear in SR
+
+ENTRY(save_low_regs)
 	stc	sr, r8
 	or	k3, r8
 	and	k4, r8
@@ -565,6 +576,7 @@ ENTRY(handle_interrupt)
 	 PREF(k0)
 
 	! Save registers / Switch to bank 0
+	mov.l	1f, k4		! SR bits to clear in k4
 	bsr	save_regs	! needs original pr value in k3
 	 mov	#-1, k2		! default vector kept in k2
 
arch/sh/kernel/cpu/sh3/swsusp.S new file +147 -0

147 lines not on this page · raw message

arch/sh/kernel/cpu/sh4/Makefile +1 -0
@@ -5,6 +5,7 @@
 obj-y	:= probe.o common.o
 common-y	+= $(addprefix ../sh3/, entry.o ex.o)
 
+obj-$(CONFIG_HIBERNATION)		+= $(addprefix ../sh3/, swsusp.o)
 obj-$(CONFIG_SH_FPU)			+= fpu.o softfloat.o
 obj-$(CONFIG_SH_STORE_QUEUES)		+= sq.o
 
arch/sh/kernel/swsusp.c new file +38 -0
@@ -0,0 +1,38 @@
+/*
+ * swsusp.c - SuperH hibernation support
+ *
+ * Copyright (C) 2009 Magnus Damm
+ *
+ * This file is subject to the terms and conditions of the GNU General Public
+ * License.  See the file "COPYING" in the main directory of this archive
+ * for more details.
+ */
+
+#include <linux/mm.h>
+#include <linux/sched.h>
+#include <linux/suspend.h>
+#include <asm/suspend.h>
+#include <asm/sections.h>
+#include <asm/tlbflush.h>
+#include <asm/page.h>
+#include <asm/fpu.h>
+
+struct swsusp_arch_regs swsusp_arch_regs_cpu0;
+
+int pfn_is_nosave(unsigned long pfn)
+{
+	unsigned long begin_pfn = __pa(&__nosave_begin) >> PAGE_SHIFT;
+	unsigned long end_pfn = PAGE_ALIGN(__pa(&__nosave_end)) >> PAGE_SHIFT;
+
+	return (pfn >= begin_pfn) && (pfn < end_pfn);
+}
+
+void save_processor_state(void)
+{
+	init_fpu(current);
+}
+
+void restore_processor_state(void)
+{
+	local_flush_tlb_all();
+}
#1 lore raw
Quoted 9 lines · Magnus Damm

Add Suspend-to-disk / swsusp / CONFIG_HIBERNATION support to the SuperH architecture V2.

To suspend, use "swapon /dev/sda2; echo disk > /sys/power/state" To resume, pass "resume=/dev/sda2" on the kernel command line.

The patch "pm: rework includes, remove arch ifdefs V2" is needed to allow the generic swsusp code to build properly.

Quoted 8 lines

Hibernation is not enabled with this patch though, a patch setting ARCH_HIBERNATION_POSSIBLE will be submitted later.

---

V2 contains changes according to feedback from Paul.

This is a good start anyways, applied.