how to create a uboot for my board
To whom this may concern:
I am using a board, CSB733. It has the microcontroller from freescale, MCiMX31VMN5C. It is having UMON as the boot loader inside. I tried to load QNX into the board but was not successful. I need to change to Uboot to try. Can someone teach me how to create a uboot to be loaded into the board? I have no experience in this and this is my first time creating a boot loader.
Your help is very much appreciated.
Hope to hear from you soon.
Thanks.
Sincerely,
Nelson
Dear "Nelson Kon Yii",
Quoted 7 lines · In message <[email protected]> you wrote:
I am using a board, CSB733. It has the microcontroller from freescale, MCiMX31VMN5C. It is having UMON as the boot loader inside. I tried to load QNX into the board but was not successful. I need to change to Uboot to try. Can someone teach me how to create a uboot to be loaded into the board? I have no experience in this and this is my first time creating a boot loader.
Read the README, it has a section "U-Boot Porting Guide" which you should study.
You might want to consider the hire_a_guru() part...
Best regards,
Wolfgang Denk
Signature · 6 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de What is wanted is not the will to believe, but the will to find out, which is the exact opposite. -- Bertrand Russell, "Skeptical Essays", 1928