Linux 2.6.x - Serial port signalling not maintained when closing device
Hello,
I'm using small devices that are connected on the serial port, and powered using RTS and DTR.
When using kernel 2.4.x (at least 2.4.31), I could easily control the powering of the device using :
stty -F /dev/ttyS0 ospeed 9600 (this would put RTS and DTR to 1 / power)
and
stty -F /dev/ttyS0 ospeed 0 (this would turn it off).
I've recently updated one of the machine to a new 2.6.29 kernel, and this is not working anymore.
As far as I can see, I need to have an application that keeps /dev/ttyS0 open for this to work. As soon as no application is using the port, everything goes down again.
This is a significant change between 2.4.x and 2.6.x. Is there a way to change 2.6.x behavior to go back to the 2.4.x ? When was this change introduce ?
This serial port controler is a 16550A, the machine is an x86 platform, so nothing unusual.
Best regards,
Paul
Quoted 3 lines
As far as I can see, I need to have an application that keeps
/dev/ttyS0open for this to work. As soon as no application is using the port, everything goes down again.
Yes - the 2.6 kernel has the newer uart driver layer and is also (throughout) much more aggressive about power management. You'll see the same with magic electronic project parallel port hacks where the port is turned off when the device file is not open.
Quoted 1 line
This is a significant change between 2.4.x and 2.6.x.
Only to your rather unusual use of things. For normal use the current behaviour is far more correct.
Quoted 3 lines
Is there a way to
change 2.6.x behavior to go back to the 2.4.x ? When was this change introduce ?
Just keep the port open when you are using it. Even in 2.4 the driver could have been unloaded on some setups if you didn't have a port open.
Alan
Quoted 8 lines · Paul Rolland
I'm using small devices that are connected on the serial port, and powered using RTS and DTR.
When using kernel 2.4.x (at least 2.4.31), I could easily control the powering of the device using :
stty -F/dev/ttyS0ospeed 9600 (this would put RTS and DTR to 1 / power)
and
stty -F/dev/ttyS0ospeed 0 (this would turn it off).
Quoted 5 lines
I've recently updated one of the machine to a new 2.6.29 kernel, and this is not working anymore.
As far as I can see, I need to have an application that keeps/dev/ttyS0open for this to work. As soon as no application is using the port, everything goes down again.
Are you explicitly clearing the HUPCL flag?
(stty -F /dev/ttyS0 -hupcl)
I just did a quick test on 2.6.22 and DTR/RTS are maintained with your commands above, but only after clearing HUPCL.
Signature · 8 lines
Paul Fulghum MicroGate Systems, Ltd. =Customer Driven, by Design= (800)444-1982 (512)345-7791 (Direct) (512)343-9046 (Fax) Central Time Zone (GMT -5h) www.microgate.com