tcg/x86_64: optimize register allocation order
RFC PATCH 1/1 tcg/x86_64: optimize register allocation order
The beginning of the register allocation order list on the TCG x86_64 target matches the list of clobbered registers. This means that when an helper is called, there is almost always some registers to clobber.
The same way register %rsi and %rdi are at the top of the register allocation order list, while they can't be used for load/store operations. This means the data and/or address registers are very often %rsi and %rdi, so a mov operation has to be inserted before and/or after doing the load/store.
This patches changes to the allocation order to avoid those effects. It results in a 8% gain speed in qemu-x86_64 to compress a bzip2 file, and a 6% gain in qemu-system-mips64 to compile a small application.
tcg/x86_64/tcg-target.c +9 -10
@@ -44,22 +44,21 @@ static const char * const tcg_target_reg_names[TCG_TARGET_NB_REGS] = {#endif static const int tcg_target_reg_alloc_order[] = { -TCG_REG_RDI , -TCG_REG_RSI , -TCG_REG_RDX , -TCG_REG_RCX , -TCG_REG_R8 , -TCG_REG_R9 , -TCG_REG_RAX , -TCG_REG_R10 , -TCG_REG_R11 , -TCG_REG_RBP ,TCG_REG_RBX ,TCG_REG_R12 ,TCG_REG_R13 ,TCG_REG_R14 ,TCG_REG_R15 , +TCG_REG_R10 , +TCG_REG_R11 , +TCG_REG_R9 , +TCG_REG_R8 , +TCG_REG_RCX , +TCG_REG_RDX , +TCG_REG_RSI , +TCG_REG_RDI , +TCG_REG_RAX , };static const int tcg_target_call_iarg_regs[6 ] = {
Signature · 2 lines
Aurelien Jarno GPG: 1024D/F1BCDB73 [email protected] http://www.aurel32.net