Skip to contentSkip to conversation

ni5010: convert to net_device_ops

PATCH Applied Alexander Beregalov 2 participants 4 messages Mar 29, 2009

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ni5010: convert to net_device_ops

---

 drivers/net/ni5010.c |   15 +++++++++------
 1 files changed, 9 insertions(+), 6 deletions(-)
drivers/net/ni5010.c +9 -6
index 539e18a..b121e0f 100644
@@ -189,6 +189,14 @@ static void __init trigger_irq(int ioaddr)
 		outb(MM_EN_XMT|MM_MUX, IE_MMODE); /* Start transmission */
 }
 
+static const struct net_device_ops ni5010_netdev_ops = {
+	.ndo_open		= ni5010_open,
+	.ndo_stop		= ni5010_close,
+	.ndo_start_xmit		= ni5010_send_packet,
+	.ndo_set_multicast_list	= ni5010_set_multicast_list,
+	.ndo_tx_timeout		= ni5010_timeout,
+};
+
 /*
  *      This is the real probe routine.  Linux has a history of friendly device
  *      probes on the ISA bus.  A good device probes avoids doing writes, and
@@ -328,13 +336,8 @@ static int __init ni5010_probe1(struct net_device *dev, int ioaddr)
         	outb(0, IE_RBUF);	/* set buffer byte 0 to 0 again */
 	}
         printk("-> bufsize rcv/xmt=%d/%d\n", bufsize_rcv, NI5010_BUFSIZE);
-	memset(netdev_priv(dev), 0, sizeof(struct ni5010_local));
 
-	dev->open		= ni5010_open;
-	dev->stop		= ni5010_close;
-	dev->hard_start_xmit	= ni5010_send_packet;
-	dev->set_multicast_list = ni5010_set_multicast_list;
-	dev->tx_timeout		= ni5010_timeout;
+	dev->netdev_ops		= &ni5010_netdev_ops;
 	dev->watchdog_timeo	= HZ/20;
 
 	dev->flags &= ~IFF_MULTICAST;	/* Multicast doesn't work */
maintainer
#1 lore raw

From: Alexander Beregalov <[email protected]>
Date: Sun, 29 Mar 2009 06:26:13 +0400

drivers/net/ni5010.c static void __init trigger_irq(int ioaddr) · line 198

Quoted 11 lines
drivers/net/ni5010.c +7 -0
@@ -189,6 +189,14 @@ static void __init trigger_irq(int ioaddr)
 		outb(MM_EN_XMT|MM_MUX, IE_MMODE); /* Start transmission */
 }
 
+static const struct net_device_ops ni5010_netdev_ops = {
+	.ndo_open		= ni5010_open,
+	.ndo_stop		= ni5010_close,
+	.ndo_start_xmit		= ni5010_send_packet,
+	.ndo_set_multicast_list	= ni5010_set_multicast_list,
+	.ndo_tx_timeout		= ni5010_timeout,
+};

Missing:

.ndo_change_mtu = eth_change_mtu,
.ndo_set_mac_address = eth_mac_addr,
.ndo_validate_addr = eth_validate_addr,

as would have been initialized to dev->foo by alloc_etherdev().

#2 lore raw
Quoted 17 lines · David Miller

From: Alexander Beregalov <[email protected]>
Date: Sun, 29 Mar 2009 06:26:13 +0400

Review static void __init trigger_irq(int ioaddr) · line 198

Quoted 11 lines
(quoted diff) +7 -0
@@ -189,6 +189,14 @@ static void __init trigger_irq(int ioaddr)
 		outb(MM_EN_XMT|MM_MUX, IE_MMODE); /* Start transmission */
 }
 
+static const struct net_device_ops ni5010_netdev_ops = {
+	.ndo_open		= ni5010_open,
+	.ndo_stop		= ni5010_close,
+	.ndo_start_xmit		= ni5010_send_packet,
+	.ndo_set_multicast_list	= ni5010_set_multicast_list,
+	.ndo_tx_timeout		= ni5010_timeout,
+};

Missing:

Quoted 5 lines

.ndo_change_mtu = eth_change_mtu,
.ndo_set_mac_address = eth_mac_addr,
.ndo_validate_addr = eth_validate_addr,

as would have been initialized to dev->foo by alloc_etherdev().

Ok, thanks.

Subject: [PATCH] ni5010: convert to net_device_ops
From: Alexander Beregalov <[email protected]>

---

 drivers/net/ni5010.c |   18 ++++++++++++------
 1 files changed, 12 insertions(+), 6 deletions(-)
drivers/net/ni5010.c +12 -6
index 539e18a..2a8da47 100644
@@ -189,6 +189,17 @@ static void __init trigger_irq(int ioaddr)
 		outb(MM_EN_XMT|MM_MUX, IE_MMODE); /* Start transmission */
 }
 
+static const struct net_device_ops ni5010_netdev_ops = {
+	.ndo_open		= ni5010_open,
+	.ndo_stop		= ni5010_close,
+	.ndo_start_xmit		= ni5010_send_packet,
+	.ndo_set_multicast_list	= ni5010_set_multicast_list,
+	.ndo_tx_timeout		= ni5010_timeout,
+	.ndo_validate_addr	= eth_validate_addr,
+	.ndo_set_mac_address	= eth_mac_addr,
+	.ndo_change_mtu		= eth_change_mtu,
+};
+
 /*
  *      This is the real probe routine.  Linux has a history of friendly device
  *      probes on the ISA bus.  A good device probes avoids doing writes, and
@@ -328,13 +339,8 @@ static int __init ni5010_probe1(struct net_device *dev, int ioaddr)
         	outb(0, IE_RBUF);	/* set buffer byte 0 to 0 again */
 	}
         printk("-> bufsize rcv/xmt=%d/%d\n", bufsize_rcv, NI5010_BUFSIZE);
-	memset(netdev_priv(dev), 0, sizeof(struct ni5010_local));
 
-	dev->open		= ni5010_open;
-	dev->stop		= ni5010_close;
-	dev->hard_start_xmit	= ni5010_send_packet;
-	dev->set_multicast_list = ni5010_set_multicast_list;
-	dev->tx_timeout		= ni5010_timeout;
+	dev->netdev_ops		= &ni5010_netdev_ops;
 	dev->watchdog_timeo	= HZ/20;
 
 	dev->flags &= ~IFF_MULTICAST;	/* Multicast doesn't work */