powerpc/pmac: Fix internal modem IRQ on Wallstreet PowerBook
PATCH 1/1 powerpc/pmac: Fix internal modem IRQ on Wallstreet PowerBook
The (relatively) new pmac_zilog driver doesn't use the pre-munged IRQ numbers from the macio_dev unlike other macio things, it directly maps it off the OF device-tree.
It does that because it can be initialized much earlier than the registration of the macio devices, in order to get a serial console early.
Unfortunately, that means that it "misses" some fixups done by the macio layer to work around missing interrupt descriptions in the device-tree of the Wallstreet machines.
This patch brings the necessary workaround into the pmac_zilog driver itself to bring it back to working condition.
Signed-off-by Benjamin Herrenschmidt <[email protected]>
---
drivers/serial/pmac_zilog.c | 15 +++++++++++++++ 1 file changed, 15 insertions(+)
drivers/serial/pmac_zilog.c +15 -0
@@ -1538,6 +1538,21 @@ no_dma: uap->port.type =PORT_PMAC_ZILOG ; uap->port.flags =0 ; +/* +* Fixup for the port on Gatwick for which the device-tree has +* missing interrupts. Normally, the macio_dev would contain +* fixed up interrupt info, but we use the device-tree directly +* here due to early probing so we need the fixup too. +*/ +if (uap->port.irq ==NO_IRQ && + np->parent && np->parent->parent && +of_device_is_compatible (np->parent->parent,"gatwick" )) { +/* IRQs on gatwick are offset by 64 */ + uap->port.irq =irq_create_mapping (NULL ,64 +15 ); + uap->tx_dma_irq =irq_create_mapping (NULL ,64 +4 ); + uap->rx_dma_irq =irq_create_mapping (NULL ,64 +5 ); + } +/* Setup some valid baud rate information in the register * shadows so we don't write crap there before baud rate is * first initialized.