NAND: davinci_nand, 4-bit ECC for smallpage
Subsystems (5)
Minimal support for the 4-bit ECC engine found on DM355 and OMAP-L137 chips. This is limited to small-page flash for now; there are special layout issues for large page chips (which, nowadays, are prevalent).
Note that the DM355 EVM uses a large-page chip -- unless you swap socketed chips -- so this version will be a bit awkward to test. The core ECC logic is unchanged from the version which was previously happy with most of the newish MTD tests.
CHANGES since my last version: says byebye to ECC_HW_SYNDROME; select this using an explicit count of how many ECC bits to use. Add brief comment about the anticipated fix for the large page issue.
# NYET Signed-off-...
--- arch/arm/mach-davinci/include/mach/nand.h | 8 drivers/mtd/nand/davinci_nand.c | 302 ++++++++++++++++++++++++++-- 2 files changed, 295 insertions(+), 15 deletions(-)
arch/arm/mach-davinci/include/mach/nand.h +6 -2
@@ -68,10 +68,14 @@ struct davinci_nand_pdata { /* platform/* none == NAND_ECC_NONE (strongly *not* advised!!) * soft == NAND_ECC_SOFT -* 1-bit == NAND_ECC_HW -* 4-bit == NAND_ECC_HW_SYNDROME (not on all chips) +* else == NAND_ECC_HW, according to ecc_bits +* +* All DaVinci-family chips support 1-bit hardware ECC. +* Newer ones support 4 bits ECC, but are awkward using +* it with large page chips. */ nand_ecc_modes_t ecc_mode; +u8 ecc_bits;/* e.g. NAND_BUSWIDTH_16 or NAND_USE_FLASH_BBT */ unsigned options;
drivers/mtd/nand/davinci_nand.c +289 -13
373 lines not on this page · raw message