hpt366: use ATA_DMA_* constants
PATCH 1/1 hpt366: use ATA_DMA_* constants
Use ATA_DMA_* constants instead of the bare numbers for the BMIDE register bits.
Signed-off-by Sergei Shtylyov <[email protected]>
---
This patch is atop the recent pata-2.6 series...
drivers/ide/hpt366.c | 10 +++++----- 1 files changed, 5 insertions(+), 5 deletions(-)
drivers/ide/hpt366.c +5 -5
@@ -3,7 +3,7 @@* Portions Copyright (C) 2001 Sun Microsystems, Inc. * Portions Copyright (C) 2003 Red Hat Inc * Portions Copyright (C) 2007 Bartlomiej Zolnierkiewicz -* Portions Copyright (C) 2005-2008 MontaVista Software, Inc. +* Portions Copyright (C) 2005-2009 MontaVista Software, Inc. * * Thanks to HighPoint Technologies for their assistance, and hardware. * Special Thanks to Jon Burchmore in SanDiego for the deep pockets, his
@@ -810,7 +810,7 @@ static void hpt370_irq_timeout(ide_drive/* get DMA command mode */ dma_cmd =inb (hwif->dma_base +ATA_DMA_CMD );/* stop DMA */ -outb (dma_cmd & ~0x1 , hwif->dma_base +ATA_DMA_CMD ); +outb (dma_cmd & ~ATA_DMA_START , hwif->dma_base +ATA_DMA_CMD );hpt370_clear_engine (drive); }
@@ -827,11 +827,11 @@ static int hpt370_dma_end(ide_drive_t *dide_hwif_t *hwif = drive->hwif;u8 dma_stat =inb (hwif->dma_base +ATA_DMA_STATUS ); -if (dma_stat &0x01 ) { +if (dma_stat &ATA_DMA_ACTIVE ) {/* wait a little */ udelay (20 ); dma_stat =inb (hwif->dma_base +ATA_DMA_STATUS ); -if (dma_stat &0x01 ) +if (dma_stat &ATA_DMA_ACTIVE )hpt370_irq_timeout (drive); }return ide_dma_end (drive);
@@ -853,7 +853,7 @@ static int hpt374_dma_test_irq(ide_drive dma_stat =inb (hwif->dma_base +ATA_DMA_STATUS );/* return 1 if INTR asserted */ -if (dma_stat &4 ) +if (dma_stat &ATA_DMA_INTR )return 1 ;return 0 ;
Bartlomiej Zolnierkiewicz
AppliedQuoted 3 lines · On Thursday 09 April 2009 14:38:50 Sergei Shtylyov wrote:
Use ATA_DMA_* constants instead of the bare numbers for the BMIDE register bits.
Signed-off-by Sergei Shtylyov <[email protected]>
applied