NAND: davinci_nand, 4-bit ECC for smallpage
Subsystems (5)
PATCH 3/3 NAND: davinci_nand, 4-bit ECC for smallpage
From: David Brownell <[email protected]>
Minimal support for the 4-bit ECC engine found on DM355, DM365, DA830/OMAP-L137, and similar recent DaVinci-family chips.
This is limited to small-page flash for now; there are some page layout issues for large page chips. Note that most boards using this engine (like the DM355 EVM) include 2GByte large page chips.
Sanity tested on DM355 EVM after swapping the socketed NAND for a small-page one.
---
Removed "RFT" from $SUBJECT; adds support for on-flash BBT.
Could stand some more testing to verify the *correction* works, but that requires writing specialized test code. U-Boot 2009.03 has a "nand biterr" command ... which is not yet implemented.
Not essential for 2.6.30; all hardware using 4-bit ECC also normally needs the large-page support (e.g. EVM boards which ship with 2 GByte chips using 2KB pages).
arch/arm/mach-davinci/include/mach/nand.h | 8 drivers/mtd/nand/davinci_nand.c | 304 ++++++++++++++++++++++++++-- 2 files changed, 297 insertions(+), 15 deletions(-)
arch/arm/mach-davinci/include/mach/nand.h +6 -2
@@ -68,10 +68,14 @@ struct davinci_nand_pdata { /* platform/* none == NAND_ECC_NONE (strongly *not* advised!!) * soft == NAND_ECC_SOFT -* 1-bit == NAND_ECC_HW -* 4-bit == NAND_ECC_HW_SYNDROME (not on all chips) +* else == NAND_ECC_HW, according to ecc_bits +* +* All DaVinci-family chips support 1-bit hardware ECC. +* Newer ones also support 4-bit ECC, but are awkward +* using it with large page chips. */ nand_ecc_modes_t ecc_mode; +u8 ecc_bits;/* e.g. NAND_BUSWIDTH_16 or NAND_USE_FLASH_BBT */ unsigned options;
drivers/mtd/nand/davinci_nand.c +291 -13
375 lines not on this page · raw message