Skip to contentSkip to conversation

powerpc: Improve decrementer accuracy

PATCH New Anton Blanchard 1 participant 1 message May 10, 2009 PowerPC

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 powerpc: Improve decrementer accuracy

I have been looking at sources of OS jitter and notice that after a long NO_HZ idle period we wakeup too early:

relative time (us) event
timer irq exit
999946.405 timer irq entry
4.835 timer irq exit
21.685 timer irq entry
3.540 timer (tick_sched_timer) entry

Here we slept for just under a second then took a timer interrupt that did nothing. 21.685 us later we wake up again and do the work.

We set a rather low shift value of 16 for the decrementer clockevent, which I think is causing this issue. On this box we have a 207MHz decrementer and see:

clockevent: decrementer mult[3501] shift[16] cpu[0]

For calculations of large intervals this mult/shift combination could be off by a significant amount. I notice the sparc code has a loop that iterates to find a mult/shift combination that maximises the shift value while keeping mult under 32bit. With the patch below we get:

clockevent: decrementer mult[35015c20] shift[32] cpu[15]

And we no longer see the spurious wakeups.

---

- I haven't tested if it does the right thing on 32bit yet

- Should we do something similar to the timebase? We use a 22 bit shift there but time might drift if that isnt accurate enough.

arch/powerpc/kernel/time.c +18 -3
Index: linux-2.6/arch/powerpc/kernel/time.c
===================================================================
@@ -110,7 +110,7 @@
 static struct clock_event_device decrementer_clockevent = {
        .name           = "decrementer",
        .rating         = 200,
-       .shift          = 16,
+       .shift          = 0,	/* To be filled in */
        .mult           = 0,	/* To be filled in */
        .irq            = 0,
        .set_next_event = decrementer_set_next_event,
@@ -852,6 +852,22 @@
 		decrementer_set_next_event(DECREMENTER_MAX, dev);
 }
 
+static void __init setup_clockevent_multiplier(unsigned long hz)
+{
+	u64 mult, shift = 32;
+
+	while (1) {
+		mult = div_sc(hz, NSEC_PER_SEC, shift);
+		if (mult && (mult >> 32UL) == 0UL)
+			break;
+
+		shift--;
+	}
+
+	decrementer_clockevent.shift = shift;
+	decrementer_clockevent.mult = mult;
+}
+
 static void register_decrementer_clockevent(int cpu)
 {
 	struct clock_event_device *dec = &per_cpu(decrementers, cpu).event;
@@ -869,8 +885,7 @@
 {
 	int cpu = smp_processor_id();
 
-	decrementer_clockevent.mult = div_sc(ppc_tb_freq, NSEC_PER_SEC,
-					     decrementer_clockevent.shift);
+	setup_clockevent_multiplier(ppc_tb_freq);
 	decrementer_clockevent.max_delta_ns =
 		clockevent_delta2ns(DECREMENTER_MAX, &decrementer_clockevent);
 	decrementer_clockevent.min_delta_ns =