sh: sh7785lcr: fix I2C device address map for 32-bit mode
PATCH 1/1 sh: sh7785lcr: fix I2C device address map for 32-bit mode
Fix the problem that cannot work RTC on 32-bit mode. The cause is because the board datasheet had a mistake.
Signed-off-by Yoshihiro Shimoda <[email protected]>
--- arch/sh/include/mach-common/mach/sh7785lcr.h | 10 +++++----- 1 files changed, 5 insertions(+), 5 deletions(-)
arch/sh/include/mach-common/mach/sh7785lcr.h +5 -5
@@ -9,11 +9,11 @@* -----------------------------+---------------+--------------- * 0x00000000 - 0x03ffffff(CS0) | NOR Flash | NOR Flash * 0x04000000 - 0x05ffffff(CS1) | PLD | PLD -* 0x06000000 - 0x07ffffff(CS1) | reserved | I2C +* 0x06000000 - 0x07ffffff(CS1) | I2C | I2C * 0x08000000 - 0x0bffffff(CS2) | USB | DDR SDRAM * 0x0c000000 - 0x0fffffff(CS3) | SD | DDR SDRAM * 0x10000000 - 0x13ffffff(CS4) | SM107 | SM107 -* 0x14000000 - 0x17ffffff(CS5) | I2C | USB +* 0x14000000 - 0x17ffffff(CS5) | reserved | USB * 0x18000000 - 0x1bffffff(CS6) | reserved | SD * 0x40000000 - 0x5fffffff | DDR SDRAM | (cannot use) *
@@ -32,6 +32,9 @@#define PLD_VERSR (PLD_BASE_ADDR + 0x0c)#define PLD_MMSR (PLD_BASE_ADDR + 0x0e) +#define PCA9564_ADDR 0x06000000/* I2C */ +#define PCA9564_SIZE 0x00000100 +#define SM107_MEM_ADDR 0x10000000#define SM107_MEM_SIZE 0x00e00000#define SM107_REG_ADDR 0x13e00000
@@ -40,16 +43,13 @@#if defined(CONFIG_SH_SH7785LCR_29BIT_PHYSMAPS )#define R8A66597_ADDR 0x14000000/* USB */ #define CG200_ADDR 0x18000000/* SD */ -#define PCA9564_ADDR 0x06000000/* I2C */ #else #define R8A66597_ADDR 0x08000000#define CG200_ADDR 0x0c000000 -#define PCA9564_ADDR 0x14000000#endif #define R8A66597_SIZE 0x00000100#define CG200_SIZE 0x00010000 -#define PCA9564_SIZE 0x00000100#endif /* __ASM_SH_RENESAS_SH7785LCR_H */
Signature · 1 line
1.5.5
Paul Mundt
AppliedQuoted 4 lines · Yoshihiro Shimoda
Fix the problem that cannot work RTC on 32-bit mode. The cause is because the board datasheet had a mistake.
Signed-off-by Yoshihiro Shimoda <[email protected]>
applied, thanks.