AFEB9260 network fix
PATCH 1/1 AFEB9260 network fix
AFEB9260 uses PA10, PA11 for ETX2 and ETX3.
Also, due to extarnal pull-up on IRQ line, Micrel PHY ID is 1 after reset sequence, not 0.
Signed-off-by Sergey Lapin <[email protected]>
--- board/afeb9260/afeb9260.c | 2 +- cpu/arm926ejs/at91/at91sam9260_macb.c | 2 +- 2 files changed, 2 insertions(+), 2 deletions(-)
board/afeb9260/afeb9260.c +1 -1
@@ -177,7 +177,7 @@ int board_eth_init(bd_t *bis) {int rc =0 ;#ifdef CONFIG_MACB - rc =macb_eth_initialize (0 , (void *)AT91SAM9260_BASE_EMAC ,0x00 ); + rc =macb_eth_initialize (0 , (void *)AT91SAM9260_BASE_EMAC ,0x01 );#endif return rc; }
cpu/arm926ejs/at91/at91sam9260_macb.c +1 -1
@@ -47,7 +47,7 @@ void at91_macb_hw_init(void)at91_set_B_periph (AT91_PIN_PA25 ,0 );/* ERX2 */ at91_set_B_periph (AT91_PIN_PA26 ,0 );/* ERX3 */ at91_set_B_periph (AT91_PIN_PA27 ,0 );/* ERXCK */ -#if defined(CONFIG_AT91SAM9260EK ) +#if defined(CONFIG_AT91SAM9260EK ) || defined(CONFIG_AFEB9260 )/* * use PA10, PA11 for ETX2, ETX3. * PA23 and PA24 are for TWI EEPROM
Signature · 1 line
1.5.6.5
Jean-Christophe PLAGNIOL-VILLARD
AppliedPATCH 1/1 AFEB9260 network fix
Quoted 6 lines · Sergey Lapin
AFEB9260 uses PA10, PA11 for ETX2 and ETX3.
Also, due to extarnal pull-up on IRQ line, Micrel PHY ID is 1 after reset sequence, not 0.Signed-off-by Sergey Lapin <[email protected]>---
Applied to arm
Best Regards,
J.
PATCH 1/1 AFEB9260 network fix
Quoted 8 lines · Jean-Christophe PLAGNIOL-VILLARD
Quoted 6 lines · Sergey Lapin
AFEB9260 uses PA10, PA11 for ETX2 and ETX3.
Also, due to extarnal pull-up on IRQ line, Micrel PHY ID is 1 after reset sequence, not 0.Signed-off-by Sergey Lapin <[email protected]>---
Applied to arm
Thanks a lot!