hwmon: PCI quirk for hwmon access on MSI
PATCH v2 1/1 hwmon: PCI quirk for hwmon access on MSI
The MSI MS-7031 is based on an ATI IXP300 south bridge. On this south bridge, accessible I/O ports must be enabled explicitly. Unfortunately the BIOS forgets to enable access to the hardware monitoring chip I/O ports, so hardware monitoring fails.
Add a quirk enabling access to the required ports (0x295-0x296). This is exactly what MSI's own hardware monitoring application is doing, so it has to be the right way.
Signed-off-by Jean Delvare <[email protected]>
--- drivers/hwmon/hwmon.c | 29 +++++++++++++++++++++++++++++ 1 file changed, 29 insertions(+)
drivers/hwmon/hwmon.c +29 -0
@@ -18,6 +18,7 @@#include <linux/hwmon.h> #include <linux/gfp.h> #include <linux/spinlock.h> +#include <linux/pci.h> #define HWMON_ID_PREFIX "hwmon"#define HWMON_ID_FORMAT HWMON_ID_PREFIX "%d"
@@ -86,8 +87,36 @@ void hwmon_device_unregister(struct devi "hwmon_device_unregister() failed: bad class ID!\n"); } +static void __init hwmon_pci_quirks (void ) +{ +#if definedCONFIG_X86 && definedCONFIG_PCI +struct pci_dev *sb; +u16 base; +u8 enable; + +/* Open access to 0x295-0x296 on MSI MS-7031 */ + sb =pci_get_device (PCI_VENDOR_ID_ATI ,0x436c ,NULL ); +if (sb && + (sb->subsystem_vendor =0x1462 &&/* MSI */ + sb->subsystem_device =0x0031 )) {/* MS-7031 */ + +pci_read_config_byte (sb,0x48 , &enable); +pci_read_config_word (sb,0x64 , &base); + +if (base =0 && !(enable &BIT (2 ))) { +dev_info (&sb->dev, +"Opening wide generic port at 0x295\n" ); +pci_write_config_word (sb,0x64 ,0x295 ); +pci_write_config_byte (sb,0x48 , enable |BIT (2 )); + } + } +#endif +} +static int __init hwmon_init (void ) { +hwmon_pci_quirks (); + hwmon_class =class_create (THIS_MODULE ,"hwmon" );if (IS_ERR (hwmon_class)) {printk (KERN_ERR "hwmon.c: couldn't create sysfs class\n" );
Signature · 6 lines
Jean Delvare _______________________________________________ lm-sensors mailing list [email protected] http://lists.lm-sensors.org/mailman/listinfo/lm-sensors