ads7846: pin change interrupt support
Subsystems (2)
PATCH 2/5 ads7846: pin change interrupt support
From: Michael Roth <[email protected]>
Some SoC supports only pin change interrupts on GPIO pins used as irq lines.
The ads7846 core is not affected from the additional irqs on the rising edge because the code accounts touch bounce anyway by kicking in a timer and disabling the irq after the first request and reenabling the irq after a timeout when there is no longer pen down detected.
Signed-off-by Michael Roth <[email protected]>
Cc Dmitry Torokhov <[email protected]>
Cc Imre Deak <[email protected]>
Signed-off-by Andrew Morton <[email protected]>
---
drivers/input/touchscreen/ads7846.c | 12 +++++++++--- 1 file changed, 9 insertions(+), 3 deletions(-)
drivers/input/touchscreen/ads7846.c renamed from drivers/input/touchscreen/ads7846.c~ads7846-pin-change-interrupt-support +9 -3
@@ -1150,9 +1150,15 @@ static int __devinit ads7846_probe(strucif (request_irq (spi->irq, ads7846_irq,IRQF_TRIGGER_FALLING , spi->dev.driver->name, ts)) { -dev_dbg (&spi->dev,"irq %d busy?\n" , spi->irq); - err = -EBUSY ; - goto err_free_gpio; +dev_info (&spi->dev, +"trying pin change workaround on irq %d\n" , spi->irq); +if (request_irq (spi->irq, ads7846_irq, +IRQF_TRIGGER_FALLING |IRQF_TRIGGER_RISING , + spi->dev.driver->name, ts)) { +dev_dbg (&spi->dev,"irq %d busy?\n" , spi->irq); + err = -EBUSY ; + goto err_free_gpio; + } } err =ads784x_hwmon_register (spi, ts);
_