Skip to contentSkip to conversation

power_supply: fix up olpc_battery's eeprom read function

PATCH In review Andres Salomon 1 participant 1 message Jun 23, 2009

lore
Share & tools
lore
#0 lore raw

PATCH 1/5 power_supply: fix up olpc_battery's eeprom read function

The eeprom read function was placing values into the wrong place in 'buf'; we were starting from buf[off], rather than buf[0].

Also, the for loop that we were using was much uglier than it needed to be. This cleans it up a bit.

---
 drivers/power/olpc_battery.c |   14 ++++++--------
 1 files changed, 6 insertions(+), 8 deletions(-)
drivers/power/olpc_battery.c +6 -8
index 5fbca26..8f41733 100644
@@ -334,21 +334,19 @@ static ssize_t olpc_bat_eeprom_read(struct kobject *kobj,
 		struct bin_attribute *attr, char *buf, loff_t off, size_t count)
 {
 	uint8_t ec_byte;
-	int ret, end;
+	int ret, i;
 
 	if (off >= EEPROM_SIZE)
 		return 0;
 	if (off + count > EEPROM_SIZE)
 		count = EEPROM_SIZE - off;
 
-	end = EEPROM_START + off + count;
-	for (ec_byte = EEPROM_START + off; ec_byte < end; ec_byte++) {
-		ret = olpc_ec_cmd(EC_BAT_EEPROM, &ec_byte, 1,
-				&buf[ec_byte - EEPROM_START], 1);
+	for (i = 0; i < count; i++) {
+		ec_byte = EEPROM_START + off + i;
+		ret = olpc_ec_cmd(EC_BAT_EEPROM, &ec_byte, 1, &buf[i], 1);
 		if (ret) {
-			printk(KERN_ERR "olpc-battery:  EC command "
-					"EC_BAT_EEPROM @ 0x%x failed -"
-					" %d!\n", ec_byte, ret);
+			printk(KERN_ERR "olpc-battery:  EC_BAT_EEPROM cmd @ 0x%x failed - %d!\n",
+					ec_byte, ret);
 			return -EIO;
 		}
 	}
Signature · 1 line
1.5.6.5