Skip to contentSkip to conversation

Make Broadcom SoC naming options consistent

PATCH In review Florian Fainelli 3 participants 4 messages Jun 25, 2009 MIPS

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Make Broadcom SoC naming options consistent

Hi Ralf, Maxime,

This patch applies to the linux-bcm63xx.git tree. Thanks --
From: Florian Fainelli <[email protected]>
Subject: [PATCH] Make Broadcom SoC naming consistent

This patch makes the Broadcom SoC naming configuration symbols consistent and to follow the Broadcom BCMXXXX naming convention (commercial naming).

---

arch/mips/Kconfig +2 -2
index d104dd2..8fdbc8f 100644
@@ -40,7 +40,7 @@ config BASLER_EXCITE
 	  Basler Vision Technologies AG.
 
 config BCM47XX
-	bool "BCM47XX based boards"
+	bool "Broadcom BCM47XX based boards"
 	select CEVT_R4K
 	select CSRC_R4K
 	select DMA_NONCOHERENT
@@ -61,7 +61,7 @@ config BCM47XX
 	 Support for BCM47XX based boards
 
 config BCM63XX
-	bool "Broadcom 63xx based boards"
+	bool "Broadcom BCM63XX based boards"
 	select CEVT_R4K
 	select CSRC_R4K
 	select DMA_NONCOHERENT
#1 lore raw
Quoted 1 line · Florian Fainelli

Hi Ralf, Maxime,

Thanks. Patch applied nad tree respun against -rc1. With the AR7 stuff finally merged this makes the BCM stuff the longest pending to be merged ...

Ralf

#2 lore raw
Quoted 3 lines · Ralf Baechle

Thanks. Patch applied nad tree respun against -rc1. With the AR7 stuff finally merged this makes the BCM stuff the longest pending to be merged ...

I'm considering removing non MIPS stuff (ethernet, usb, pcmcia) from the patchset for the moment. Getting ACKs from all subsystems on the same merge window is too difficult.

That way you could merge the CPU support in your tree, and the drivers could go via subsystems trees on the next merge window.

What do you think ?

Signature · 1 line
Maxime
#3 lore raw
Quoted 4 lines · Maxime Bizon
Quoted 3 lines

Thanks. Patch applied nad tree respun against -rc1. With the AR7 stuff finally merged this makes the BCM stuff the longest pending to be merged ...

Quoted 8 lines

I'm considering removing non MIPS stuff (ethernet, usb, pcmcia) from the patchset for the moment. Getting ACKs from all subsystems on the same merge window is too difficult.

That way you could merge the CPU support in your tree, and the drivers could go via subsystems trees on the next merge window.

What do you think ?

Agreed. I think I'll start off by posting the whole series to the list for everybody's reviewing pleassure then let's sort the whole thing.

Ralf