adjusting lowmem_reserve_ratio on an embedded system?
Hello,
in tracing a low on memory situation on an embedded system I came across the Documentation/sysctl/vm.txt. There it is advised to change the lowmem_reserve_ratio on systems running without swap.
I wonder if this applies for an embedded system running with 256MByte RAM and no swap which is using only one memory zone (ZONE_NORMAL)? I guess no.
To understand what the parameter means I read the relevant section from vm.txt and came across the terms "lowmem zone" and "lower zones" and "lowmem memory". I feel dumb. I could not find a concept of "lower zones" (or "upper" zones). What exactly do they mean?
Cheers
Daniel
Quoted 11 lines · On Wed, 1 Jul 2009 14:23:52 +0200 Daniel Kabs <[email protected]> wrote:
Hello,
in tracing a low on memory situation on an embedded system I came across the
Documentation/sysctl/vm.txt. There it is advised to change thelowmem_reserve_ratioon systems running without swap.I wonder if this applies for an embedded system running with 256MByte RAM and no swap which is using only one memory zone (
ZONE_NORMAL)? I guess no.
Quoted 5 lines
To understand what the parameter means I read the relevant section from vm.txt and came across the terms "lowmem zone" and "lower zones" and "lowmem memory". I feel dumb. I could not find a concept of "lower zones" (or "upper" zones). What exactly do they mean?
Assume a system with HIGHMEM/NORMAL/DMA
zone fallback list is created as
HIGHMEM->NORMAL->DMA
HIGHMEM's lower zone is NORMAL+DMA
NORMAL's lower zone is DMA.
"lowmem" often means NORMAL+DMA (yes, there are HIGHMEM) but it depends on context.
Regards,
-Kame