xscale: fix USB initialization for Trizepsiv module
PATCH 1/1 xscale: fix USB initialization for Trizepsiv module
Due to change in the usb_board_init() prototype, the USB for the TrizepsIV was not correctly initialized. Removed dummy print from usb_board_stop().
Signed-off-by Stefano Babic <[email protected]>
--- board/trizepsiv/conxs.c | 5 +++-- 1 files changed, 3 insertions(+), 2 deletions(-)
board/trizepsiv/conxs.c +3 -2
@@ -55,7 +55,7 @@ extern struct serial_device serial_stuart_device;* Miscelaneous platform dependent initialisations */ -void usb_board_init (void ) +int usb_board_init (void ) {UHCHR = (UHCHR |UHCHR_PCPL |UHCHR_PSPL ) & ~(UHCHR_SSEP0 |UHCHR_SSEP1 |UHCHR_SSEP2 |UHCHR_SSE );
@@ -76,6 +76,8 @@ void usb_board_init(void)/* Set port power control mask bits, only 3 ports. */ UHCRHDB |= (0x7 <<17 ); + +return 0 ; }void usb_board_init_fail (void )
@@ -94,7 +96,6 @@ void usb_board_stop(void)CKEN &= ~CKEN10_USBHOST ; -puts ("Called USB STOP\n" );return ; }
Signature · 1 line
1.6.0.4
PATCH 1/1 xscale: add support for the polaris board
Quoted 11 lines · Stefano Babic
The Polaris board is based on the TrizepsIV module of Keith & Koep (http://www.keith-koep.com).
Signed-off-by Stefano Babic <[email protected]>--- MAINTAINERS | 5 +++++ MAKEALL | 2 ++ Makefile | 7 ++++++- board/trizepsiv/conxs.c | 22 ++++++++++++---------- include/configs/trizepsiv.h | 25 ++++++++++++++++++++++--- 5 files changed, 47 insertions(+), 14 deletions(-)
Applied to u-boot-arm
Best Regards,
J.
PATCH 1/1 xscale: fix USB initialization for Trizepsiv module
In reply to Stefano BabicQuoted 8 lines · Stefano Babic
Due to change in the
usb_board_init()prototype, the USB for the TrizepsIV was not correctly initialized. Removed dummy print fromusb_board_stop().Signed-off-by Stefano Babic <[email protected]>--- board/trizepsiv/conxs.c | 5 +++-- 1 files changed, 3 insertions(+), 2 deletions(-)
Applied to u-boot-arm
Best Regards,
J.