p54: re-enable power save feature
PATCH RESEND 1/1 p54: re-enable power save feature
This patch re-enables p54's power save features and adds a workaround which temporarily alters the device's power state in order to allow ps-polls to be sent and buffered data to be retrieved during psm.
Signed-off-by Christian Lamparter <[email protected]>
---
drivers/net/wireless/p54/fwio.c +4 -3
@@ -584,7 +584,8 @@ int p54_set_ps(struct p54_common *priv)unsigned int i;u16 mode; -if (priv->hw->conf.flags &IEEE80211_CONF_PS ) +if (priv->hw->conf.flags &IEEE80211_CONF_PS && + !priv->powersave_override) mode =P54_PSM |P54_PSM_BEACON_TIMEOUT |P54_PSM_DTIM |P54_PSM_CHECKSUM |P54_PSM_MCBC ;else
@@ -606,8 +607,8 @@ int p54_set_ps(struct p54_common *priv) psm->beacon_rssi_skip_max =200 ; psm->rssi_delta_threshold =0 ; - psm->nr =10 ; - psm->exclude[0 ] =0 ; + psm->nr =1 ; + psm->exclude[0 ] =WLAN_EID_TIM ;p54_tx (priv, skb);return 0 ;
drivers/net/wireless/p54/lmac.h +3 -0
@@ -548,4 +548,7 @@ int p54_upload_key(struct p54_common *priv, u8 algo, int slot,int p54_download_eeprom (struct p54_common *priv,void *buf,u16 offset,u16 len); +/* utility */ +u8 *p54_find_ie (struct sk_buff *skb,u8 ie); +#endif /* LMAC_H */
drivers/net/wireless/p54/main.c +48 -29
111 lines not on this page · raw message
drivers/net/wireless/p54/p54.h +1 -0
@@ -208,6 +208,7 @@ struct p54_common {u32 tsf_low32, tsf_high32;u32 basic_rate_mask;u16 aid; +bool powersave_override;__le32 beacon_req_id;/* cryptographic engine information */
drivers/net/wireless/p54/txrx.c +42 -0
54 lines not on this page · raw message