Skip to contentSkip to conversation

x86,apic - set cpu_has_apic for discrete apic

RFC In review Cyrill Gorcunov 2 participants 5 messages Jul 11, 2009 – Jul 12, 2009 x86

lore
Share & tools
lore
#0 lore raw

RFC 1/1 x86,apic - set cpu_has_apic for discrete apic

In case of discrete apic (due to hardware or firmware reason) cpuid may not retrieve cpu_has_apic bit. So for SMP compiled kernels instead of long check we may set "fake" cpu_has_apic bit and check only the bit in further code flow.

---

Please review carefully.

 arch/x86/kernel/apic/apic.c |   14 ++++++++++++++
 1 file changed, 14 insertions(+)
arch/x86/kernel/apic/apic.c +14 -0
Index: linux-2.6.git/arch/x86/kernel/apic/apic.c
=====================================================================
@@ -1003,6 +1003,20 @@ int __init verify_local_APIC(void)
 	unsigned int reg0, reg1;
 
 	/*
+	 * For discrete APIC case cpu_has_apic bit could not
+	 * be retrieved via cpuid instruction. Same time
+	 * we rely on this bit (mostly for SMP compiled
+	 * kernel) and instead of checking the long condition
+	 * below all the time we do check for plain cpu_has_apic.
+	 *
+	 * At this moment all the checks are passed and we've
+	 * already complained if there was a BIOS bug. This place
+	 * should be safe for such a trick. --cvg
+	 */
+	if (smp_found_config && !cpu_has_apic && !disable_apic)
+		set_cpu_cap(&boot_cpu_data, X86_FEATURE_APIC);
+
+	/*
 	 * The version register is read-only in a real APIC.
 	 */
 	reg0 = apic_read(APIC_LVR);
#1 lore raw
Quoted 10 lines · Cyrill Gorcunov

In case of discrete apic (due to hardware or firmware reason) cpuid may not retrieve cpu_has_apic bit. So for SMP compiled kernels instead of long check we may set "fake" cpu_has_apic bit and check only the bit in further code flow.

---

Please review carefully.

Sure: how did you test it or plan to do so?

Maciej

#2 lore raw

[Maciej W. Rozycki - Sun, Jul 12, 2009 at 01:41:54AM +0100]

| On Sun, 12 Jul 2009, Cyrill Gorcunov wrote:
| 
| > In case of discrete apic (due to hardware or firmware reason)
| > cpuid may not retrieve cpu_has_apic bit. So for SMP
| > compiled kernels instead of long check we may set "fake"
| > cpu_has_apic bit and check only the bit in further code
| > flow.
| > 
| > Signed-off-by: Cyrill Gorcunov <[email protected]>
| > ---
| > 
| > Please review carefully.
| 
|  Sure: how did you test it or plan to do so?
| 
|   Maciej
| 

Well, I've been using code reading. No real hardware test.
I just don't have such a hardware.

I've a two pretty old laptops will check today if they
are discrete apic based systems.

Also I was thinking about spurious software tests --
ie to set discrete apic manually but actually I don't think it will help.

And also I hoped that Ingo has a hw farm even with
discrete apic maybe... :)

-- Cyrill

#3 lore raw
Quoted 2 lines · Cyrill Gorcunov

Well, I've been using code reading. No real hardware test.
I just don't have such a hardware.

Then simulate it! Proofreading is not enough -- the APIC code is too
twisted. Be imaginative -- for example you can clear the APIC bit at the time CPUID flags are saved for later use with cpu_has_apic() and see if the code behaves as expected. Sprinkle printk()s here and there to see if variables are set correctly, whether the right code paths are taken, etc. Tedious? Well, who said kernel debugging was going to be a piece of cake?

Most of the APIC support code I have written has been run-time tested
like this -- one change at a time. Do you think I have an infinite number of SMP configurations too? All the clean-ups I worked on last year were tested with one laptop. I didn't even have a serial port for console dumps back then.

NAK from me until you've tested it, sorry.

Maciej

#4 lore raw

[Maciej W. Rozycki - Sun, Jul 12, 2009 at 07:31:44AM +0100]

| On Sun, 12 Jul 2009, Cyrill Gorcunov wrote:
| 
| >   Well, I've been using code reading. No real hardware test.
| > I just don't have such a hardware.
| 
|  Then simulate it!  Proofreading is not enough -- the APIC code is too 
| twisted.  Be imaginative -- for example you can clear the APIC bit at the 
| time CPUID flags are saved for later use with cpu_has_apic() and see if 
| the code behaves as expected.  Sprinkle printk()s here and there to see if 
| variables are set correctly, whether the right code paths are taken, etc.  
| Tedious?  Well, who said kernel debugging was going to be a piece of cake?
| 
|  Most of the APIC support code I have written has been run-time tested 
| like this -- one change at a time.  Do you think I have an infinite number 
| of SMP configurations too?  All the clean-ups I worked on last year were 
| tested with one laptop.  I didn't even have a serial port for console 
| dumps back then.
| 
|  NAK from me until you've tested it, sorry.

Started to... hope to publish results today!
Thanks Maciej!

| 
|   Maciej
| 

-- Cyrill