Skip to contentSkip to conversation

Powernow: Enable more than 2 low P-states

PATCH New Mark Langsdorf 1 participant 1 message Aug 22, 2009 x86

lore
Share & tools
lore

Mark Langsdorf

author
#0 lore raw

PATCH 1/1 Powernow: Enable more than 2 low P-states

Remove an obsolete check that used to prevent there being more than 2 low P-states. Now that low-to-low P-states changes are enabled, it prevents otherwise workable configurations with multiple low P-states.

Signed-off-by Mark Langsdorf <[email protected]>
Tested-by Krists Krilovs <[email protected]>
---
 arch/x86/kernel/cpu/cpufreq/powernow-k8.c |   29 ++++-------------------------
 1 files changed, 4 insertions(+), 25 deletions(-)
arch/x86/kernel/cpu/cpufreq/powernow-k8.c +4 -25
index 2a50ef8..0cbce04 100644
@@ -854,6 +854,10 @@ static int powernow_k8_cpu_init_acpi(struct powernow_k8_data *data)
 		goto err_out;
 	}
 
+	/* fill in data */
+	data->numps = data->acpi_data.state_count;
+	powernow_k8_acpi_pst_values(data, 0);
+
 	if (cpu_family == CPU_HW_PSTATE)
 		ret_val = fill_powernow_table_pstate(data, powernow_table);
 	else

@@ -866,11 +870,8 @@ static int powernow_k8_cpu_init_acpi(struct powernow_k8_data *data)
 	powernow_table[data->acpi_data.state_count].index = 0;
 	data->powernow_table = powernow_table;
 
-	/* fill in data */
-	data->numps = data->acpi_data.state_count;
 	if (cpumask_first(cpu_core_mask(data->cpu)) == data->cpu)
 		print_basics(data);
-	powernow_k8_acpi_pst_values(data, 0);
 
 	/* notify BIOS that we exist */
 	acpi_processor_notify_smm(THIS_MODULE);

@@ -941,7 +942,6 @@ static int fill_powernow_table_fidvid(struct powernow_k8_data *data,
 		struct cpufreq_frequency_table *powernow_table)
 {
 	int i;
-	int cntlofreq = 0;
 
 	for (i = 0; i < data->acpi_data.state_count; i++) {
 		u32 fid;

@@ -982,27 +982,6 @@ static int fill_powernow_table_fidvid(struct powernow_k8_data *data,
 			continue;
 		}
 
-		/* verify only 1 entry from the lo frequency table */
-		if (fid < HI_FID_TABLE_BOTTOM) {
-			if (cntlofreq) {
-				/* if both entries are the same,
-				 * ignore this one ... */
-				if ((freq != powernow_table[cntlofreq].frequency) ||
-				    (index != powernow_table[cntlofreq].index)) {
-					printk(KERN_ERR PFX
-						"Too many lo freq table "
-						"entries\n");
-					return 1;
-				}
-
-				dprintk("double low frequency table entry, "
-						"ignoring it.\n");
-				invalidate_entry(data, i);
-				continue;
-			} else
-				cntlofreq = i;
-		}
-
 		if (freq != (data->acpi_data.states[i].core_frequency * 1000)) {
 			printk(KERN_INFO PFX "invalid freq entries "
 				"%u kHz vs. %u kHz\n", freq,