LRO: improve aggregation in case of zero TSecr packets
Subsystems (2)
PATCH 1/1 LRO: improve aggregation in case of zero TSecr packets
This fixes a temporary performance issue we noticed in back to back TSO - LRO tests when such tests are run within five minutes after boot.
The TSval field of TCP packets is filled in based on the current jiffie, which is initialized at -300*HZ. That means that in 5 minutes after reboot it will wrap to zero.
While the jiffie value is 0 on the LRO side, TCP packets will be send out with TSVal zero as well. The TSO side will respond with packets in which TSecr is set to zero.
At this point LRO will avoid aggregating the packets, suddenly putting a lot of pressure on the stack which will result in drops and retransmission for a short while.
There are cases where aggregating zero TSecr is better and cases in which is not:
1. non zero TSecr packets, zero TSecr packet
Better not to aggregate, otherwise we miss a valid TSecr.
2. zero TSecr packets (amplified by TSO)
Better to aggregate.
3. zero TSecr packet, non zero TSecr packets
OK to aggregate.
4. non zero TSecr packets, zero TSecr packets, non zero TSecr packet
OK to aggregate, but not a big overhead if we aggregate in 2 segments instead of one.
This patch allows aggregation for cases 2 and 3 as well as aggregation in 2 segments for case 4, while denying aggregation in case 1.
--- net/ipv4/inet_lro.c | 4 ++-- 1 files changed, 2 insertions(+), 2 deletions(-)
net/ipv4/inet_lro.c +2 -2
@@ -90,9 +90,9 @@ static int lro_tcp_ip_check(struct iphdr *iph, struct tcphdr *tcph, ntohl(*topt)))return -1 ; -/* timestamp reply should not be zero */ +/* aggregate if we are sure we won't miss a valid TSecr */ topt++; -if (*topt ==0 ) +if (*topt ==0 && lro_desc->tcp_rcv_tsecr !=0 )return -1 ; }
David Miller
maintainerFrom: Octavian Purdila <[email protected]>
Date: Thu, 27 Aug 2009 02:08:31 +0300
Quoted 7 lines
This fixes a temporary performance issue we noticed in back to back TSO - LRO tests when such tests are run within five minutes after boot.
The TSval field of TCP packets is filled in based on the current jiffie, which is initialized at -300*HZ. That means that in 5 minutes after reboot it will wrap to zero.
RFC1323 says we absolutely must ignore zero TSecr values.
It is a bug that the stack emits a zero value when it means to give a real TSecr value that will be used.
Probably we can do something like emit '1' when we would emit '0' based upon jiffies.
And this would be an improvement from now in that having a off-by-one TSecr in this situation is better than emitting one which we can guarentee will be ignored.
Quoted 16 lines · On Monday 31 August 2009 08:11:05 David Miller wrote:
From: Octavian Purdila <[email protected]>
Date: Thu, 27 Aug 2009 02:08:31 +0300Quoted 7 lines
This fixes a temporary performance issue we noticed in back to back TSO - LRO tests when such tests are run within five minutes after boot.
The TSval field of TCP packets is filled in based on the current jiffie, which is initialized at -300*HZ. That means that in 5 minutes after reboot it will wrap to zero.
RFC1323 says we absolutely must ignore zero TSecr values.
It is a bug that the stack emits a zero value when it means to give a real TSecr value that will be used.
Quoted 6 lines
Probably we can do something like emit '1' when we would emit '0' based upon jiffies.
And this would be an improvement from now in that having a off-by-one TSecr in this situation is better than emitting one which we can guarentee will be ignored.
Right, why did I thought that the LRO TSecr issue can happen even when emitting a right TSval ? :-/
I'll follow with a patch which takes this approach.
Thanks,
tavi
Quoted 4 lines · Octavian Purdila
This fixes a temporary performance issue we noticed in back to back TSO - LRO tests when such tests are run within five minutes after boot.
Sorry for responding to old emails again but just for the record, please keep in mind that LRO is going away so you really should run your tests with GRO (and update the driver if necessary) as otherwise your efforts may end up being wasted.
In this particular instance, you're trying to fix an issue that GRO already fixes.
Cheers,
Signature · 4 lines
Visit Openswan at http://www.openswan.org/
Email: Herbert Xu ~{PmV>HI~} <[email protected]>
Home Page: http://gondor.apana.org.au/~herbert/
PGP Key: http://gondor.apana.org.au/~herbert/pubkey.txt