Reset i2c slave devices during init on mpc5xxx cpus
PATCH v2 1/1 Reset i2c slave devices during init on mpc5xxx cpus
Reset any i2c devices that may have been interrupted during a system reset. Normally this would be accomplished by clocking the line until SCL and SDA are released and then sending a start condtiion (From an Atmel datasheet). There is no direct access to the i2c pins so instead create start commands through the i2c interface. Send a start command then delay for the SDA Hold time, repeat this by disabling/enabling the bus a total of 9 times.
---
changes since v1
- Fixed compiler warning
README | 7 ++++++ cpu/mpc5xxx/i2c.c | 49 ++++++++++++++++++++++++++++++++++++++++++ include/configs/galaxy5200.h | 1 + 3 files changed, 57 insertions(+), 0 deletions(-)
README +7 -0
@@ -1366,6 +1366,13 @@ The following options need to be configured: therefore be cleared to 0 (See, eg, MPC823e User's Manual p.16-473). So, set CONFIG_SYS_I2C_SLAVE to 0. + CONFIG_SYS_I2C_INIT_MPC5XXX + + When a board is reset during an i2c bus transfer + chips might think that the current transfer is still + in progress. Reset the slave devices by sending start + commands until the slave device responds. + That's all that's required for CONFIG_HARD_I2C. If you use the software i2c interface (CONFIG_SOFT_I2C)
cpu/mpc5xxx/i2c.c +49 -0
61 lines not on this page · raw message
include/configs/galaxy5200.h +1 -0
@@ -110,6 +110,7 @@#define CONFIG_SYS_I2C_MODULE 2/* Select I2C module #1 or #2 */ #define CONFIG_SYS_I2C_SPEED 100000/* 100 kHz */ #define CONFIG_SYS_I2C_SLAVE 0x7F +#define CONFIG_SYS_I2C_INIT_MPC5XXX /* Reset devices on i2c bus */ /* * EEPROM CAT24WC32 configuration
Signature · 1 line
1.6.3.1
PATCH v2 1/1 Reset i2c slave devices during init on mpc5xxx cpus
Hello Eric,
Quoted 7 lines · Eric Millbrandt
Reset any i2c devices that may have been interrupted during a system reset. Normally this would be accomplished by clocking the line until SCL and SDA are released and then sending a start condtiion (From an Atmel datasheet). There is no direct access to the i2c pins so instead create start commands through the i2c interface. Send a start command then delay for the SDA Hold time, repeat this by disabling/enabling the bus a total of 9 times.
Quoted 5 lines
Signed-off-by Eric Millbrandt <[email protected]>---
changes since v1
- Fixed compiler warning
Applied to u-boot-i2c.git
Thanks for your work,
bye
Heiko
Signature · 2 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany