omap_hsmmc: set open drain bit correctly
Subsystems (2)
PATCH 56/232 omap_hsmmc: set open drain bit correctly
From: Denis Karpov <[email protected]>
The code could set the bit to 1 but not reset it to 0.
Signed-off-by Denis Karpov <[email protected]>
Signed-off-by Adrian Hunter <[email protected]>
Acked-by Matt Fleming <[email protected]>
Cc Ian Molton <[email protected]>
Cc "Roberto A. Foglietta" <[email protected]>
Cc Jarkko Lavinen <[email protected]>
Cc Denis Karpov <[email protected]>
Cc Pierre Ossman <[email protected]>
Cc Philip Langdale <[email protected]>
Cc "Madhusudhan" <[email protected]>
Cc <[email protected]>
Signed-off-by Andrew Morton <[email protected]>
---
drivers/mmc/host/omap_hsmmc.c | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-)
drivers/mmc/host/omap_hsmmc.c renamed from drivers/mmc/host/omap_hsmmc.c~omap_hsmmc-set-open-drain-bit-correctly +4 -2
@@ -1118,9 +1118,11 @@ static void omap_mmc_set_ios(struct mmc_if (do_send_init_stream)send_init_stream (host); + con =OMAP_HSMMC_READ (host->base,CON );if (ios->bus_mode ==MMC_BUSMODE_OPENDRAIN ) -OMAP_HSMMC_WRITE (host->base,CON , -OMAP_HSMMC_READ (host->base,CON ) |OD ); +OMAP_HSMMC_WRITE (host->base,CON , con |OD ); +else +OMAP_HSMMC_WRITE (host->base,CON , con & ~OD );mmc_host_lazy_disable (host->mmc); }
_