Skip to contentSkip to conversation

sdhci-of: cleanup eSDHC's set_clock() a little bit

PATCH In review [email protected] 1 participant 1 message Sep 22, 2009

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 83/232 sdhci-of: cleanup eSDHC's set_clock() a little bit

From: Anton Vorontsov <[email protected]>

- Get rid of incomprehensible "if { for { if } }" construction for the exponential divisor calculation. The first if statement isn't correct at all, since it should check for "host->max_clk / pre_div / 16 > clock". The error doesn't cause any bugs because the check in the for loop does the right thing, and so the outer check becomes useless;

- For the linear divisor do the same: a single while statement is more readable than for + if construction;

- Add dev_dbg() that prints desired and actual clock frequency.

Cc Pierre Ossman <[email protected]>
Cc Kumar Gala <[email protected]>
Cc David Vrabel <[email protected]>
Cc Ben Dooks <[email protected]>
Cc Sascha Hauer <[email protected]>

---

 drivers/mmc/host/sdhci-of.c |   19 ++++++++-----------
 1 file changed, 8 insertions(+), 11 deletions(-)
drivers/mmc/host/sdhci-of.c renamed from drivers/mmc/host/sdhci-of.c~sdhci-of-cleanup-esdhcs-set_clock-a-little-bit +8 -11
diff -puN drivers/mmc/host/sdhci-of.c~sdhci-of-cleanup-esdhcs-set_clock-a-little-bit drivers/mmc/host/sdhci-of.c
@@ -121,8 +121,8 @@ static void esdhc_writeb(struct sdhci_ho
 
 static void esdhc_set_clock(struct sdhci_host *host, unsigned int clock)
 {
-	int div;
 	int pre_div = 2;
+	int div = 1;
 
 	clrbits32(host->ioaddr + ESDHC_SYSTEM_CONTROL, ESDHC_CLOCK_IPGEN |
 		  ESDHC_CLOCK_HCKEN | ESDHC_CLOCK_PEREN | ESDHC_CLOCK_MASK);
@@ -130,17 +130,14 @@ static void esdhc_set_clock(struct sdhci
 	if (clock == 0)
 		goto out;
 
-	if (host->max_clk / 16 > clock) {
-		for (; pre_div < 256; pre_div *= 2) {
-			if (host->max_clk / pre_div < clock * 16)
-				break;
-		}
-	}
+	while (host->max_clk / pre_div / 16 > clock && pre_div < 256)
+		pre_div *= 2;
 
-	for (div = 1; div <= 16; div++) {
-		if (host->max_clk / (div * pre_div) <= clock)
-			break;
-	}
+	while (host->max_clk / pre_div / div > clock && div < 16)
+		div++;
+
+	dev_dbg(mmc_dev(host->mmc), "desired SD clock: %d, actual: %d\n",
+		clock, host->max_clk / pre_div / div);
 
 	pre_div >>= 1;
 	div--;

_