Skip to contentSkip to conversation

net: enable smsc911x on MIPS

PATCH Applied Manuel Lauss 3 participants 5 messages Oct 13, 2009 – Oct 14, 2009

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/2 net: enable smsc911x on MIPS

---
 drivers/net/Kconfig |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)
drivers/net/Kconfig +1 -1
index 7127760..d9772af 100644
@@ -1001,7 +1001,7 @@ config SMC911X
 
 config SMSC911X
 	tristate "SMSC LAN911x/LAN921x families embedded ethernet support"
-	depends on ARM || SUPERH || BLACKFIN
+	depends on ARM || SUPERH || BLACKFIN || MIPS
 	select CRC32
 	select MII
 	select PHYLIB
Signature · 1 line
1.6.5.rc2
#1 lore raw

PATCH 2/2 net: smsc911x: allow platform_data to specify mac address

Extend the driver to accept a MAC address specified in platform_data.

---
 drivers/net/smsc911x.c   |    3 +++
 include/linux/smsc911x.h |    1 +
 2 files changed, 4 insertions(+), 0 deletions(-)
drivers/net/smsc911x.c +3 -0
index ccdd196..6a9f51d 100644
@@ -2071,6 +2071,9 @@ static int __devinit smsc911x_drv_probe(struct platform_device *pdev)
 	if (is_valid_ether_addr(dev->dev_addr)) {
 		smsc911x_set_hw_mac_address(pdata, dev->dev_addr);
 		SMSC_TRACE(PROBE, "MAC Address is specified by configuration");
+	} else if (is_valid_ether_addr(pdata->config.mac)) {
+		memcpy(dev->dev_addr, pdata->config.mac, 6);
+		SMSC_TRACE(PROBE, "MAC Address specified by platform data");
 	} else {
 		/* Try reading mac address from device. if EEPROM is present
 		 * it will already have been set */
include/linux/smsc911x.h +1 -0
index 5241e4f..7144e8a 100644
@@ -30,6 +30,7 @@ struct smsc911x_platform_config {
 	unsigned int irq_type;
 	unsigned int flags;
 	phy_interface_t phy_interface;
+	unsigned char mac[6];
 };
 
 /* Constants for platform_device irq polarity configuration */
Signature · 1 line
1.6.5.rc2