Skip to contentSkip to conversation

Booting automatically a binary image

U-Boot Ivan Llopard 2 participants 3 messages Oct 14, 2009

lore
Share & tools
lore
#0 lore raw

Hi list,

I'd like to know how to configure u-boot in order to boot automatically a binary image, so when i reset my board i can get my program running. What code is important in order to do it? or where can i get a reference?

Regards,
Ivan Llopard.

#1 lore raw

Dear Ivan Llopard,

Quoted 4 lines · In message <[email protected]> you…

I'd like to know how to configure u-boot in order to boot automatically a binary image, so when i reset my board i can get my program running. What code is important in order to do it? or where can i get a reference?

I suggest you start reading the manual, see
http://www.denx.de/wiki/DULG/Manual

Pay special attention to the parts that describe the use of environment variables, and there especially the sections about the "bootcmd" variable. It may also help to read about the "setenv" and "saveenv" commands.

Best regards,

Wolfgang Denk

Signature · 5 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
I'm frequently appalled by the low regard you Earthmen have for life.
	-- Spock, "The Galileo Seven", stardate 2822.3
#2 lore raw

Thanks Wolfgang, i'll take a look.

2009/10/14 Wolfgang Denk <[email protected]>

Quoted 28 lines

Dear Ivan Llopard,

In message <[email protected]>

Quoted 4 lines · you

I'd like to know how to configure u-boot in order to boot automatically a binary image, so when i reset my board i can get my program running. What code is important in order to do it? or where can i get a reference?

I suggest you start reading the manual, see
http://www.denx.de/wiki/DULG/Manual

Pay special attention to the parts that describe the use of environment variables, and there especially the sections about the "bootcmd" variable. It may also help to read about the "setenv" and "saveenv" commands.

Best regards,

Wolfgang Denk

--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de I'm frequently appalled by the low regard you Earthmen have for life.

       -- Spock, "The Galileo Seven", stardate 2822.3