tps65010: Allow the board to choose any GPIO base.
If the board does not care where the TPS turns up, then specifiying the value -1 to get gpiolib to dynamically allocate the base for the chip is valid.
Change the test to look for != 0, so that any boards specifying zero will not end up with gpio that they didn't want.
Signed-off-by Ben Dooks <[email protected]>
Signed-off-by Simtec Liunx Team <[email protected]>
--- drivers/mfd/tps65010.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/mfd/tps65010.c +1 -1
@@ -637,7 +637,7 @@ static int tps65010_probe(struct i2c_cli tps, DEBUG_FOPS);/* optionally register GPIOs */ -if (board && board->base >0 ) { +if (board && board->base !=0 ) { tps->outmask = board->outmask; tps->chip.label = client->name;
Signature · 3 lines
Ben ([email protected], http://www.fluff.org/) 'a smiley only costs 4 bytes'
Samuel Ortiz
AppliedHi Ben,
Quoted 9 lines · Ben Dooks
If the board does not care where the TPS turns up, then specifiying the value -1 to get gpiolib to dynamically allocate the base for the chip is valid.
Change the test to look for != 0, so that any boards specifying zero will not end up with gpio that they didn't want.
Signed-off-by Ben Dooks <[email protected]>Signed-off-by Simtec Liunx Team <[email protected]>
Applied, thanks a lot.
Quoted 22 lines
--- drivers/mfd/tps65010.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)Index:
b/drivers/mfd/tps65010.c
===================================================================drivers/mfd/tps65010.c +1
-1@@ -637,7 +637,7 @@ static int tps65010_probe(struct i2c_cli tps, DEBUG_FOPS);/* optionally register GPIOs */ -if (board && board->base >0 ) { +if (board && board->base !=0 ) { tps->outmask = board->outmask; tps->chip.label = client->name;Signature · 4 lines
-- Ben ([email protected], http://www.fluff.org/) 'a smiley only costs 4 bytes'
Signature · 2 lines
Intel Open Source Technology Centre http://oss.intel.com/