staging: rt2860: remove superfluous newlines
PATCH 2/3 staging: rt2860: remove superfluous newlines
From: Sebastian Dalfuß <[email protected]>
Subject: [Patch 2/3] staging: rt2860: remove superfluous newlines
This patch is based on 2.6.32-rc6
This tiny patch removes a few quite unnecessary extra newlines from DBGPRINT() and printk() strings.
Signed-off-by Sebastian Dalfuß <[email protected]>
---
drivers/staging/rt2860/common/dfs.c +1 -1
@@ -367,7 +367,7 @@// channel availability check time is 60sec, use 65 for assurance if (pAd->CommonCfg.RadarDetect.RDCount++ > pAd->CommonCfg.RadarDetect.ChMovingTime) { -DBGPRINT (RT_DEBUG_TRACE , ("Not found radar signal, start send beacon and radar detection in service monitor\n\n" )); +DBGPRINT (RT_DEBUG_TRACE , ("Not found radar signal, start send beacon and radar detection in service monitor\n" ));BbpRadarDetectionStop (pAd);AsicEnableBssSync (pAd); pAd->CommonCfg.RadarDetect.RDMode =RD_NORMAL_MODE ;
drivers/staging/rt2860/common/rtmp_init.c +2 -2
@@ -244,7 +244,7 @@break ; } pAd->BeaconBuf = pBeaconBuf; -printk ("\n\n=== pAd = %p, size = %d ===\n\n" , pAd, (UINT32 )sizeof (RTMP_ADAPTER )); +printk ("=== pAd = %p, size = %d ===\n" , pAd, (UINT32 )sizeof (RTMP_ADAPTER ));// Init spin locks
@@ -3031,7 +3031,7 @@if (Index >1000 ) { Status =NDIS_STATUS_FAILURE ; -DBGPRINT (RT_DEBUG_ERROR , ("NICLoadFirmware: MCU is not ready\n\n\n" )); +DBGPRINT (RT_DEBUG_ERROR , ("NICLoadFirmware: MCU is not ready\n" )); }/* End of if */ DBGPRINT(RT_DEBUG_TRACE,
drivers/staging/rt2860/rt_linux.c +1 -1
@@ -384,7 +384,7 @@ { *ppPacket =NULL ;#ifdef DEBUG -printk ("RTMPAllocateNdisPacket Fail\n\n" ); +printk ("RTMPAllocateNdisPacket Fail\n" );#endif return NDIS_STATUS_FAILURE ; }