Skip to contentSkip to conversation

Nomadik: fix reset_timer()

PATCH Superseded Alessandro Rubini 1 participant 1 message Nov 6, 2009

v2 of 4 Superseded Latest is v4 →

lore
Share & tools
lore
#0 lore raw

PATCH v2 1/1 Nomadik: fix reset_timer()

From: Alessandro Rubini <[email protected]>

Previously the code wrote 0 to reset the counter and used negation to read an increasing value from the register. However, a readback before 400us still returned 0, which was reported as 1780 seconds, thus nand failed to work any now and then. As suggested by Wolfgang Denk, this changes READ_TIMER to just return the hardware counter (a declerasing one) and changes code using the value. Compile-tested only, at this point.

---

Please note that V3 is being posted at the same time. I prefer V3 to this V2, but V2 is how I've been asked to do things.

 cpu/arm926ejs/nomadik/timer.c |   14 +++++++-------
 1 files changed, 7 insertions(+), 7 deletions(-)
cpu/arm926ejs/nomadik/timer.c +7 -7
index 16067c9..c7dd65d 100644
@@ -34,8 +34,8 @@
 #define TICKS_PER_HZ		(TIMER_CLOCK / CONFIG_SYS_HZ)
 #define TICKS_TO_HZ(x)		((x) / TICKS_PER_HZ)
 
-/* macro to read the 32 bit timer: since it decrements, we invert read value */
-#define READ_TIMER() (~readl(CONFIG_SYS_TIMERBASE + MTU_VAL(0)))
+/* macro to read the 32 bit timer: note however that the count decreases */
+#define READ_TIMER() readl(CONFIG_SYS_TIMERBASE + MTU_VAL(0))
 
 /* Configure a free-running, auto-wrap counter with no prescaler */
 int timer_init(void)
@@ -46,7 +46,7 @@ int timer_init(void)
 	return 0;
 }
 
-/* Restart counting from 0 */
+/* Restart counting from 0 (still, it is a decrementing counter) */
 void reset_timer(void)
 {
 	writel(0, CONFIG_SYS_TIMERBASE + MTU_LR(0)); /* Immediate effect */
@@ -55,7 +55,7 @@ void reset_timer(void)
 /* Return how many HZ passed since "base" */
 ulong get_timer(ulong base)
 {
-	return  TICKS_TO_HZ(READ_TIMER()) - base;
+	return  TICKS_TO_HZ(-READ_TIMER()) - base;
 }
 
 /* Delay x useconds */
@@ -63,8 +63,8 @@ void udelay(unsigned long usec)
 {
 	ulong ini, end;
 
-	ini = READ_TIMER();
-	end = ini + USEC_TO_COUNT(usec);
-	while ((signed)(end - READ_TIMER()) > 0)
+	ini = READ_TIMER(); /* decrementing value */
+	end = ini - USEC_TO_COUNT(usec);
+	while ((signed)(READ_TIMER() - end) > 0)
 		;
 }
Signature · 1 line
1.6.0.2