GPMC setup help
I've been going round and round on this for a couple of days. I have a logic analyzer (cheap USB, that is why come edges are not quite synced) attached to the gpmc pins on a logicpd dev board. The read cycle timings are what I expect.
The write cycle seems to do one cycle OK, then thing go into the weeds.
Here are the values I write into the registers:
GPMC_CONFIG1 reg: 1200
GPMC_CONFIG2 reg: 40400
GPMC_CONFIG3 reg: 20201
GPMC_CONFIG4 reg: 4030403
GPMC_CONFIG5 reg: 1040505
GPMC_CONFIG6 reg: 4030000
and here is a screen shot of the logic analyzer:
http://balister.dyndns.org:8008/~balister/gpmc-write.png
Philip
Hi,
Quoted 17 lines · Philip Balister
I've been going round and round on this for a couple of days. I have a logic analyzer (cheap USB, that is why come edges are not quite synced) attached to the gpmc pins on a logicpd dev board. The read cycle timings are what I expect.
The write cycle seems to do one cycle OK, then thing go into the weeds.
Here are the values I write into the registers:
GPMC_CONFIG1reg: 1200
GPMC_CONFIG2reg: 40400
GPMC_CONFIG3reg: 20201
GPMC_CONFIG4reg: 4030403
Quoted 7 lines
GPMC_CONFIG5reg: 1040505
GPMC_CONFIG6reg: 4030000and here is a screen shot of the logic analyzer:
This won't help with your current problem probably..
But once you get things working, please take a look the gpmc.c. The GPMC values should be dynamically calculated depending on the L3 speed. There are several examples of that in gpmc-onenand.c and gpmc-smc91x.c.
You should be able to calculate the timings needed from the external device data sheets. Also, Paul noted earlier that for some devices you also need to add up the latencies for the level shifter.
Then while at it, maybe check with your logic analyzer to make sure the timings set using gpmc.c really are what we're trying them to? I don't think anybody has ever verified that.
Regards,
Tony