Skip to contentSkip to conversation

man page update - default value of *-max-failure

PATCH New Libor Pechacek 1 participant 1 message Nov 12, 2009 PPP protocol drivers and compressors

lore
Share & tools
lore
#0 lore raw

PATCH 1/3 man page update - default value of *-max-failure

Default maximum number of NAKs received before sending REJs was changed to 5 by commit e9543fef. There does not seem to be a special value for IPX, therefore I change 3 to 5 for ipxcp-max-failure too.

---
 pppd/pppd.8 |    6 +++---
 1 files changed, 3 insertions(+), 3 deletions(-)
pppd/pppd.8 +3 -3
index 8ea8200..47c5c40 100644
@@ -455,7 +455,7 @@ Set the maximum number of IPv6CP configure-request transmissions to
 .TP
 .B ipv6cp\-max\-failure \fIn
 Set the maximum number of IPv6CP configure-NAKs returned before starting
-to send configure-Rejects instead to \fIn\fR (default 10).
+to send configure-Rejects instead to \fIn\fR (default 5).
 .TP
 .B ipv6cp\-max\-terminate \fIn
 Set the maximum number of IPv6CP terminate-request transmissions to
@@ -522,7 +522,7 @@ system will send to \fIn\fR. The default is 10.
 .TP
 .B ipxcp\-max\-failure \fIn
 Set the maximum number of IPXCP NAK frames which the local system will
-send before it rejects the options. The default value is 3.
+send before it rejects the options. The default value is 5.
 .TP
 .B ipxcp\-max\-terminate \fIn
 Set the maximum nuber of IPXCP terminate request frames before the
@@ -572,7 +572,7 @@ Set the maximum number of LCP configure-request transmissions to
 .TP
 .B lcp\-max\-failure \fIn
 Set the maximum number of LCP configure-NAKs returned before starting
-to send configure-Rejects instead to \fIn\fR (default 10).
+to send configure-Rejects instead to \fIn\fR (default 5).
 .TP
 .B lcp\-max\-terminate \fIn
 Set the maximum number of LCP terminate-request transmissions to
Signature · 1 line
1.6.0.2