Mystique SaTiX DVB-S2 [KNC ONE] - Kernel panic
Hello,
I am having problems with Mystique SaTiX DVB-S2 card.
Using the latest drivers from linuxtv.org.
Every time I use the card kernel panic occurs.
For example when trying to scan transponder.
Kernel panic - not syncing: stack-protector: Kernel stack is corrupted in: fb40d12f
I have tried to use kexec to make a vmcore dump, but the gdb only shows:
[root@alinux ~]# gdb ./vmlinux ./vmcore.dvb_v4l
...
(gdb) bt
#0 0xc017e781 in ?? ()
#1 0x00000000 in ?? ()
(gdb)
The card on windows works fine.
Is it a driver problem?
Is there a way I could extract more information about this issue?
Any help would be really appreciated.
Some more info:
dmesgudget_av 0000:01:08.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
IRQ 17/: IRQF_DISABLED is not guaranteed on shared IRQs
saa7146: found saa7146 @ mem fb108e00 (revision 1, irq 17) (0x1894,0x0019). saa7146 (0): dma buffer size 192512
DVB: registering new adapter (KNC1 DVB-S2)
adapter failed MAC signature check
encoded MAC from EEPROM was ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ffbudget_av: saa7113_init(): saa7113 not found on KNC card
KNC1-0: MAC addr = 00:09:d6:65:2d:92
saa7146 (0) saa7146_i2c_writeout [irq]: timed out waiting for end of xferstb0899_attach: Attaching STB0899tda8261_attach: Attaching TDA8261 8PSK/QPSK tuner
DVB: registering adapter 0 frontend 0 (STB0899 Multistandard)... dvb_ca_en50221_init
budget-av: ci interface initialised.dvb_ca_en50221_thread
budget-av: cam inserted Abudget_av: ciintf_slot_reset(): ciintf_slot_resetdvb_ca adapter 0: DVB CAM detected and initialised successfully
lspci -vv
01:08.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
Subsystem: KNC One Device 0019
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium
Quoted 1 line
TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 64 (3750ns min, 9500ns max)
Interrupt: pin A routed to IRQ 17
Region 0: Memory at feadfe00 (32-bit, non-prefetchable) [size=512] Kernel driver in use: budget_av
Kernel modules: budget-av
Thanks in advance.
Folnin Vi
Am Montag, 28. September 2009 18:59:19 schrieb Folnin Vi:
Quoted 9 lines
I am having problems with Mystique SaTiX DVB-S2 card.
Using the latest drivers from linuxtv.org.
Every time I use the card kernel panic occurs.
For example when trying to scan transponder.Kernel panic - not syncing: stack-protector: Kernel stack is corruptedin:
fb40d12f
Have you gained any progress with this problem? - Actually I think this only happens when the v4l-dvb is compiled with gcc 4.4 - using gcc 4.3 works around it. Can you confirm this?
Besides I am quite clueless what's causing this issue so far.
-Julian