powerpc/macio: Add dma_parms support to macio
Subsystems (3)
PATCH 2/5 powerpc/macio: Add dma_parms support to macio
This adds dma_parms to macio devices and initializes them with default values. This will allow pata_macio to setup the appropriate max segment size for the block layer.
Signed-off-by Benjamin Herrenschmidt <[email protected]>
---
arch/powerpc/include/asm/macio.h | 1 + drivers/macintosh/macio_asic.c | 5 +++++ 2 files changed, 6 insertions(+)
arch/powerpc/include/asm/macio.h +1 -0
@@ -39,6 +39,7 @@ struct macio_devstruct macio_bus *bus;/* macio bus this device is on */ struct macio_dev *media_bay;/* Device is part of a media bay */ struct of_device ofdev; +struct device_dma_parameters dma_parms;/* ide needs that */ int n_resources;struct resource resource[MACIO_DEV_COUNT_RESOURCES ];int n_interrupts;
drivers/macintosh/macio_asic.c +5 -0
@@ -379,6 +379,11 @@ static struct macio_dev * macio_add_one_ dev->ofdev.dev.parent = parent; dev->ofdev.dev.bus = &macio_bus_type; dev->ofdev.dev.release = macio_release_dev; + dev->ofdev.dev.dma_parms = &dev->dma_parms; + +/* Standard DMA paremeters */ +dma_set_max_seg_size (&dev->ofdev.dev,65536 ); +dma_set_seg_boundary (&dev->ofdev.dev,0xffffffff );#ifdef CONFIG_PCI /* Set the DMA ops to the ones from the PCI device, this could be