help: Correct syntax of nandecc help output.
PATCH 1/1 help: Correct syntax of nandecc help output.
"nandecc" help output should not reproduce the command name, nor have a trailing newline.
Signed-off-by Robert P. J. Day <[email protected]>
---
compiled, loaded and run to verify correct output.
cpu/arm_cortexa8/omap3/board.c +1 -1
@@ -328,7 +328,7 @@ usage:U_BOOT_CMD ( nandecc,2 ,1 , do_switch_ecc, -"nandecc - switch OMAP3 NAND ECC calculation algorithm\n" , +"switch OMAP3 NAND ECC calculation algorithm" ,"[hw/sw] - Switch between NAND hardware (hw) or software (sw) ecc algorithm" );
========================================================================
Robert P. J. Day Waterloo, Ontario, CANADA
Linux Consulting, Training and Kernel Pedantry.
Web page: http://crashcourse.ca Twitter: http://twitter.com/rpjday
========================================================================
Wolfgang Denk
AppliedPATCH 1/1 help: Correct syntax of nandecc help output.
Dear "Robert P. J. Day",
Quoted 5 lines · In message <alpine.LFD.2.00.0911170728050.13922@localhost> you wrote:
"nandecc" help output should not reproduce the command name, nor have a trailing newline.
Signed-off-by Robert P. J. Day <[email protected]>
Applied, thanks.
Tom, Sandeep, I hope this is OK with you.
Best regards,
Wolfgang Denk
Signature · 6 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de FORTRAN? The syntactically incorrect statement "DO 10 I = 1.10" will parse and generate code creating a variable, DO10I, as follows: "DO10I = 1.10" If that doesn't terrify you, it should.