sh: fix size calculation for NUMA node 0
PATCH 1/1 sh: fix size calculation for NUMA node 0
From: Magnus Damm <[email protected]>
Fix the NUMA size calculation for node 0. Do the same as the UMA version of setup_memory() and use address instead of pfn when calculating the size.
---
arch/sh/mm/numa.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
arch/sh/mm/numa.c +1 -1
@@ -28,7 +28,7 @@ void __init setup_memory(void) {unsigned long free_pfn =PFN_UP (__pa (_end));u64 base = min_low_pfn <<PAGE_SHIFT ; -u64 size = (max_low_pfn <<PAGE_SHIFT ) - min_low_pfn; +u64 size = (max_low_pfn <<PAGE_SHIFT ) - base;lmb_add (base, size);
Quoted 3 lines · Magnus Damm
Fix the NUMA size calculation for node 0. Do the same as the UMA version of
setup_memory()and use address instead of pfn when calculating the size.
Quoted 3 lines · Magnus Damm
This patch updates the NUMA version of
setup_memory()with UMA code changes and also modifies the last argument tolmb_alloc_base()to use an address instead of pfn.
Quoted 5 lines · Magnus Damm
This patch adds a ->start_transfer() callback to the driver
sh_mobile_lcdcfb.c. The callback is used to program the LCDC panel in the case of one-shot mode.Needed by the LCD controller used on the KFR2R09 board.
Quoted 9 lines · Magnus Damm
This patch adds a ->start_transfer() callback to the KFR2R09 lcd handling code. The callback is used to notify the lcd controller that a new frame of data is about to be transferred. The callback is only used in combination with deferred io, but the code has been tested both with and without deferred io enabled.
Without this patch the display data on the KFR2R09 lcd panel becomes corrupted over time.
All applied, thanks.