Skip to contentSkip to conversation

Microcode Module Hangs - Won't Load Microcode

DISCUSSION Frank Peters 1 participant 1 message Dec 13, 2009

lore
Share & tools
lore
#0 lore raw

This is not a new problem. I do not recall exactly when I first noticed it but it has existed for at least a few years. The issue is not serious and thus I have not reported it previously.

Whenever I load the microcode module using modprobe, the process seems to hang and requires about four minutes to complete. After the module is finally loaded, the microcode data cannot be installed to the CPU using the microcode_ctl utility.

Here is the kernel log after executing "modprobe microcode." My machine is a Core 2 Quad and has four CPU's.

Dec 11 23:24:25 (none) kernel: microcode: CPU0 sig=0x6fb, pf=0x10, revision=0xb6
Dec 11 23:24:25 (none) kernel: platform microcode: firmware: requesting intel-ucode/06-0f-0b
Dec 11 23:25:25 (none) kernel: microcode: CPU1 sig=0x6fb, pf=0x10, revision=0xb6
Dec 11 23:25:25 (none) kernel: platform microcode: firmware: requesting intel-ucode/06-0f-0b
Dec 11 23:26:25 (none) kernel: microcode: CPU2 sig=0x6fb, pf=0x10, revision=0xb6
Dec 11 23:26:25 (none) kernel: platform microcode: firmware: requesting intel-ucode/06-0f-0b
Dec 11 23:27:25 (none) kernel: microcode: CPU3 sig=0x6fb, pf=0x10, revision=0xb6
Dec 11 23:27:25 (none) kernel: platform microcode: firmware: requesting intel-ucode/06-0f-0b
Dec 11 23:28:25 (none) kernel: Microcode Update Driver: v2.00 <[email protected]>, Peter Oruba

Notice that there is a one minute wait for each CPU. This should not be happening.

Furthermore, the log indicates that the microcode module is successfully loaded, but yet no microcode data can be installed using the command:

microcode_ctl -f /etc/microcode.dat

The result of the command reports that the microcode data has been loaded but the kernel log shows nothing when it should indicate a successful install. Also, the same command can be repeated again and again and it will always report that new microcode data has been loaded. This behavior indicates that the microcode data has not been loaded.

Currently I am using kernel 2.6.32 but this problem has been observed for several previous versions (how far back it goes I cannot be certain).

What can be done to solve or debug this issue?

As I mentioned, the problem is not serious, but the microcode driver should function as advertised.

Please CC to "frank.peters at comcast.net" as I am not subscribed to the list.

Frank Peters