ixgbe: allow tx of pre-formatted vlan tagged packets
Subsystems (2)
PATCH 1/1 ixgbe: allow tx of pre-formatted vlan tagged packets
From: Gurucharan Shetty <[email protected]>
When the 82598 is fed 802.1q packets, it chokes with an error of the form:
ixgbe: eth0: ixgbe_tx_csum: partial checksum but proto=81!
As the logic there was not smart enough to look into the vlan header to pick out the encapsulated protocol.
There are times when we'd like to send these packets out without having to configure a vlan on the interface. Here we check for the vlan tag and allow the packet to go out with the correct hardware checksum.
This patch is a clone of a previously submitted patch by Arthur Jones <[email protected]> for igb (Commit - fa4a7ef36ec834fee1719636b30d2f28f4cb0166).
---
drivers/net/ixgbe/ixgbe_main.c | 13 ++++++++++++- 1 files changed, 12 insertions(+), 1 deletions(-)
drivers/net/ixgbe/ixgbe_main.c +12 -1
@@ -5006,7 +5006,18 @@ static bool ixgbe_tx_csum(struct ixgbe_adapter *adapter, IXGBE_ADVTXD_DTYP_CTXT);if (skb->ip_summed ==CHECKSUM_PARTIAL ) { -switch (skb->protocol) { +__be16 protocol; + +if (skb->protocol ==cpu_to_be16 (ETH_P_8021Q )) { +const struct vlan_ethhdr *vhdr = + (const struct vlan_ethhdr *)skb->data; + + protocol = vhdr->h_vlan_encapsulated_proto; + }else { + protocol = skb->protocol; + } + +switch (protocol) {case cpu_to_be16 (ETH_P_IP ): type_tucmd_mlhl |=IXGBE_ADVTXD_TUCMD_IPV4 ;if (ip_hdr (skb)->protocol ==IPPROTO_TCP )
From: Jeff Kirsher <[email protected]>
Date: Tue, 15 Dec 2009 15:00:31 -0800
Quoted 6 lines
From: Gurucharan Shetty <[email protected]>
When the 82598 is fed 802.1q packets, it chokes with an error of the form:
ixgbe: eth0:
ixgbe_tx_csum: partial checksum but proto=81!
...
Quoted 4 lines
Signed-off-by Gurucharan Shetty <[email protected]>Signed-off-by Arthur Jones <[email protected]>Signed-off-by Jeff Kirsher <[email protected]>
Applied.