Skip to contentSkip to conversation

vxge: use DMA_BIT_MASK instead of plain values.

PATCH Applied Denis Kirjanov <[email protected] 2 participants 2 messages Dec 16, 2009 – Dec 26, 2009

Subsystems (2)
Networking Network drivers
lore
Share & tools
lore

Denis Kirjanov <[email protected]

author
#0 lore raw

PATCH 1/1 vxge: use DMA_BIT_MASK instead of plain values.

Use DMA_BIT_MASK instead of plain values.

Signed-off-by Denis Kirjanov <[email protected]>

---

drivers/net/vxge/vxge-main.c | 6 +++---

 1 files changed, 3 insertions(+), 3 deletions(-)
drivers/net/vxge/vxge-main.c +3 -3
index f1c4b2a..0fdfd58 100644
@@ -4087,21 +4087,21 @@ vxge_probe(struct pci_dev *pdev, const struct pci_device_id *pre)
 		goto _exit0;
 	}
 
-	if (!pci_set_dma_mask(pdev, 0xffffffffffffffffULL)) {
+	if (!pci_set_dma_mask(pdev, DMA_BIT_MASK(64))) {
 		vxge_debug_ll_config(VXGE_TRACE,
 			"%s : using 64bit DMA", __func__);
 
 		high_dma = 1;
 
 		if (pci_set_consistent_dma_mask(pdev,
-						0xffffffffffffffffULL)) {
+						DMA_BIT_MASK(64))) {
 			vxge_debug_init(VXGE_ERR,
 				"%s : unable to obtain 64bit DMA for "
 				"consistent allocations", __func__);
 			ret = -ENOMEM;
 			goto _exit1;
 		}
-	} else if (!pci_set_dma_mask(pdev, 0xffffffffUL)) {
+	} else if (!pci_set_dma_mask(pdev, DMA_BIT_MASK(32))) {
 		vxge_debug_ll_config(VXGE_TRACE,
 			"%s : using 32bit DMA", __func__);
 	} else {