Skip to contentSkip to conversation

u-boot coldfire linux and fdt

U-Boot Philippe De Muyter 2 participants 2 messages Feb 21, 2010 – Feb 25, 2010

lore
Share & tools
lore
#0 lore raw

Hello Tsi Chung Liew,

I have installed u-boot and linux on a in-house-made coldfire mcf5484 based board. As u-boot currently supports mcf5484-based development boards, I used that as a starting point for the u-boot port for our in-house board.

For linux unfortunately I needed to stick with the ltib-based version of linux-2.6.25 for mcf5484-based development boards distributed by freescale.

I have discovered the hard way that that version of linux does not use the mac addresses for the ethernet ports as known by u-boot under the names "ethaddr" and "eth1addr", but uses the same wrong mac-address for all the boards.

Now it seems that the old way to communicate the mac addresses from u-boot to linux using the struct bd_info has been deprecated and removed from u-boot sources. I see some fdt-related functions in the u-boot sources, but I am not sure that the fdt blob is given to linux, or that linux for coldfire expects to get and use a fdt blob.

Can you enlighten me regarding that point, especially for mcf5484 boards ?

Thanks in advance

Philippe

#1 lore raw

Hi Philippe,

ColdFire Linux does use the MAC address, the issue is that the kernel does not pass the MAC address properly to the FEC driver. I will pass up this issue to the Linux team to have it fix soon.

The bd_info struct is still there and has not removed from u-boot source.

There is a plan of implementing fdt.

Regards,
TsiChung

Quoted 30 lines · Philippe De Muyter

Hello Tsi Chung Liew,

I have installed u-boot and linux on a in-house-made coldfire mcf5484 based board. ?As u-boot currently supports mcf5484-based development boards, I used that as a starting point for the u-boot port for our in-house board.

For linux unfortunately I needed to stick with the ltib-based version of linux-2.6.25 for mcf5484-based development boards distributed by freescale.

I have discovered the hard way that that version of linux does not use the mac addresses for the ethernet ports as known by u-boot under the names "ethaddr" and "eth1addr", but uses the same wrong mac-address for all the boards.

Now it seems that the old way to communicate the mac addresses from u-boot to linux using the struct bd_info has been deprecated and removed from u-boot sources. ?I see some fdt-related functions in the u-boot sources, but I am not sure that the fdt blob is given to linux, or that linux for coldfire expects to get and use a fdt blob.

Can you enlighten me regarding that point, especially for mcf5484 boards ?

Thanks in advance

Philippe
_______________________________________________
U-Boot mailing list
U-Boot at lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot