sh: remove dead LED code for migo-r and ms7724se
PATCH 1/1 sh: remove dead LED code for migo-r and ms7724se
From: Magnus Damm <[email protected]>
CONFIG_PM is always set on SH-Mobile these days so get rid of the unused LED setup code.
Signed-off-by Magnus Damm <[email protected]>
---
arch/sh/boards/mach-migor/setup.c | 12 ------------ arch/sh/boards/mach-se/7724/setup.c | 17 ----------------- 2 files changed, 29 deletions(-)
arch/sh/boards/mach-migor/setup.c +0 -12
@@ -496,23 +496,11 @@ static int __init migor_devices_setup(vo &migor_sdram_enter_end, &migor_sdram_leave_start, &migor_sdram_leave_end); -#ifdef CONFIG_PM /* Let D11 LED show STATUS0 */ gpio_request (GPIO_FN_STATUS0 ,NULL );/* Lit D12 LED show PDSTATUS */ gpio_request (GPIO_FN_PDSTATUS ,NULL ); -#else -/* Lit D11 LED */ -gpio_request (GPIO_PTJ7 ,NULL ); -gpio_direction_output (GPIO_PTJ7 ,1 ); -gpio_export (GPIO_PTJ7 ,0 ); - -/* Lit D12 LED */ -gpio_request (GPIO_PTJ5 ,NULL ); -gpio_direction_output (GPIO_PTJ5 ,1 ); -gpio_export (GPIO_PTJ5 ,0 ); -#endif /* SMC91C111 - Enable IRQ0, Setup CS4 for 16-bit fast access */ gpio_request (GPIO_FN_IRQ0 ,NULL );
arch/sh/boards/mach-se/7724/setup.c +0 -17
@@ -607,7 +607,6 @@ static int __init devices_setup(void)/* turn on USB clocks, use external clock */ __raw_writew ((__raw_readw (PORT_MSELCRB ) & ~0xc000 ) |0x8000 ,PORT_MSELCRB ); -#ifdef CONFIG_PM /* Let LED9 show STATUS2 */ gpio_request (GPIO_FN_STATUS2 ,NULL );
@@ -616,22 +615,6 @@ static int __init devices_setup(void)/* Lit LED11 show PDSTATUS */ gpio_request (GPIO_FN_PDSTATUS ,NULL ); -#else -/* Lit LED9 */ -gpio_request (GPIO_PTJ6 ,NULL ); -gpio_direction_output (GPIO_PTJ6 ,1 ); -gpio_export (GPIO_PTJ6 ,0 ); - -/* Lit LED10 */ -gpio_request (GPIO_PTJ5 ,NULL ); -gpio_direction_output (GPIO_PTJ5 ,1 ); -gpio_export (GPIO_PTJ5 ,0 ); - -/* Lit LED11 */ -gpio_request (GPIO_PTJ7 ,NULL ); -gpio_direction_output (GPIO_PTJ7 ,1 ); -gpio_export (GPIO_PTJ7 ,0 ); -#endif /* enable USB0 port */ __raw_writew (0x0600 ,0xa40501d4 );