hpsa: remove unneeded defines
Subsystems (2)
PATCH 1/1 hpsa: remove unneeded defines
Patch 1/1
From: Mike Miller <[email protected]>
This patch removes unnecessary #define's from hpsa. The SCSI midlayer handles all this for us.
Signed-off-by Mike Miller <[email protected]>
drivers/scsi/hpsa.c +0 -8
@@ -2708,14 +2708,6 @@ static void fill_cmd(struct CommandList *c, u8 cmd, struct ctlr_info *h, c->Request.CDB[8 ] = (size >>8 ) &0xFF ; c->Request.CDB[9 ] = size &0xFF ;break ; - -case HPSA_READ_CAPACITY : - c->Request.CDBLen =10 ; - c->Request.Type.Attribute =ATTR_SIMPLE ; - c->Request.Type.Direction =XFER_READ ; - c->Request.Timeout =0 ; - c->Request.CDB[0 ] = cmd; -break ;case HPSA_CACHE_FLUSH : c->Request.CDBLen =12 ; c->Request.Type.Attribute =ATTR_SIMPLE ;
drivers/scsi/hpsa_cmd.h +0 -15
@@ -152,21 +152,6 @@ struct SenseSubsystem_info {u8 reserved1[1108 ]; }; -#define HPSA_READ_CAPACITY 0x25/* Read Capacity */ -struct ReadCapdata { -u8 total_size[4 ];/* Total size in blocks */ -u8 block_size[4 ];/* Size of blocks in bytes */ -}; - -#if 0 -/* 12 byte commands not implemented in firmware yet. */ -#define HPSA_READ 0xa8 -#define HPSA_WRITE 0xaa -#endif - -#define HPSA_READ 0x28/* Read(10) */ -#define HPSA_WRITE 0x2a/* Write(10) */ -/* BMIC commands */ #define BMIC_READ 0x26#define BMIC_WRITE 0x27