Skip to contentSkip to conversation

ar9170usb: remove deprecated aggregation code

PATCH New Christian Lamparter 1 participant 1 message May 1, 2010

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ar9170usb: remove deprecated aggregation code

This patch removes the incomplete AMPDU implementation in ar9170usb.

The code in question is:
* too big and complex (more than 550 SLOC.)
This is enough to qualify for a new separate code file!

* unbalanced quantity & quality
over-engineered areas like:
* xmit scheduling and queuing frames for multiple HT peers
* redundant frame sorting
are confronted by gaping holes:
* accurate transmission feedback
* firmware error-handling and device reset
* HT rate control algorithm

* error-prone
Since its inclusion, hardly anything was done to fix any of the outlined flaws from the initial commit message.

=> This also indicates poor maintainability.

* relies heavily on several spinlocks.

As a result of this shortcomings, the code is slow and does not even support the most basic 11n requirement: HT station mode.

Therefore, I request to purge my heap of **** from the kernel:
"ar9170: implement transmit aggregation".

The next item on the agenda is: (re-)start from scratch with an adequate design to accommodate the special requirements and features of the available frameworks and tools.

---
Note:

While this 'generic' ampdu implementation has failed to deliver for ar9170usb, it is performing rather well in a different project called" carl9170". Don't confuse these two.
---

drivers/net/wireless/ath/ar9170/ar9170.h +2 -50
index dc662b7..4f845f8 100644
@@ -109,41 +109,6 @@ struct ar9170_rxstream_mpdu_merge {
 	bool has_plcp;
 };
 
-#define AR9170_NUM_TID	16
-#define WME_BA_BMP_SIZE         64
-#define AR9170_NUM_MAX_AGG_LEN	(2 * WME_BA_BMP_SIZE)
-
-#define WME_AC_BE   2
-#define WME_AC_BK   3
-#define WME_AC_VI   1
-#define WME_AC_VO   0
-
-#define TID_TO_WME_AC(_tid)				\
-	((((_tid) == 0) || ((_tid) == 3)) ? WME_AC_BE :	\
-	 (((_tid) == 1) || ((_tid) == 2)) ? WME_AC_BK :	\
-	 (((_tid) == 4) || ((_tid) == 5)) ? WME_AC_VI :	\
-	 WME_AC_VO)
-
-#define BAW_WITHIN(_start, _bawsz, _seqno) \
-	((((_seqno) - (_start)) & 0xfff) < (_bawsz))
-
-enum ar9170_tid_state {
-	AR9170_TID_STATE_INVALID,
-	AR9170_TID_STATE_SHUTDOWN,
-	AR9170_TID_STATE_PROGRESS,
-	AR9170_TID_STATE_COMPLETE,
-};
-
-struct ar9170_sta_tid {
-	struct list_head list;
-	struct sk_buff_head queue;
-	u8 addr[ETH_ALEN];
-	u16 ssn;
-	u16 tid;
-	enum ar9170_tid_state state;
-	bool active;
-};
-
 struct ar9170_tx_queue_stats {
 	unsigned int len;
 	unsigned int limit;
@@ -152,14 +117,11 @@ struct ar9170_tx_queue_stats {
 
 #define AR9170_QUEUE_TIMEOUT		64
 #define AR9170_TX_TIMEOUT		8
-#define AR9170_BA_TIMEOUT		4
 #define AR9170_JANITOR_DELAY		128
 #define AR9170_TX_INVALID_RATE		0xffffffff
 
-#define AR9170_NUM_TX_STATUS		128
-#define AR9170_NUM_TX_AGG_MAX		30
-#define AR9170_NUM_TX_LIMIT_HARD       AR9170_TXQ_DEPTH
-#define AR9170_NUM_TX_LIMIT_SOFT       (AR9170_TXQ_DEPTH - 10)
+#define AR9170_NUM_TX_LIMIT_HARD	AR9170_TXQ_DEPTH
+#define AR9170_NUM_TX_LIMIT_SOFT	(AR9170_TXQ_DEPTH - 10)
 
 struct ar9170 {
 	struct ieee80211_hw *hw;
@@ -234,11 +196,6 @@ struct ar9170 {
 	struct sk_buff_head tx_pending[__AR9170_NUM_TXQ];
 	struct sk_buff_head tx_status[__AR9170_NUM_TXQ];
 	struct delayed_work tx_janitor;
-	/* tx ampdu */
-	struct sk_buff_head tx_status_ampdu;
-	spinlock_t tx_ampdu_list_lock;
-	struct list_head tx_ampdu_list;
-	atomic_t tx_ampdu_pending;
 
 	/* rxstream mpdu merge */
 	struct ar9170_rxstream_mpdu_merge rx_mpdu;
@@ -250,11 +207,6 @@ struct ar9170 {
 	u8 global_ampdu_factor;
 };
 
-struct ar9170_sta_info {
-	struct ar9170_sta_tid agg[AR9170_NUM_TID];
-	unsigned int ampdu_max_len;
-};
-
 struct ar9170_tx_info {
 	unsigned long timeout;
 };
drivers/net/wireless/ath/ar9170/main.c +10 -548

715 lines not on this page · raw message