hwmon: (tmp102) Various fixes
Subsystems (2)
PATCH 1/3 hwmon: (tmp102) Various fixes
Fixes from my driver review:
http://lists.lm-sensors.org/pipermail/lm-sensors/2010-March/028051.html
Only the small changes are in there, more important changes will come later separately as time permits.
* Drop the remnants of the now gone detect function
* The TMP102 has no known compatible chip
* Include the right header files
* Clarify why byte swapping of register values is needed
* Strip resolution info bit from temperature register value
* Set cache lifetime to 1/3 second
* Don't arbitrarily reject limit values; clamp as needed
* Make limit writing unconditional
* Don't check for transaction types the driver doesn't use
* Properly check for error when setting configuration
* Report error on failed probe
* Make the driver load automatically where needed
* Various other minor fixes
--- Documentation/hwmon/tmp102 | 9 ++--- drivers/hwmon/Kconfig | 2 - drivers/hwmon/tmp102.c | 69 +++++++++++++++++++++----------------------- 3 files changed, 39 insertions(+), 41 deletions(-)
Documentation/hwmon/tmp102 +4 -5
@@ -4,7 +4,7 @@ Kernel driver tmp102 Supported chips: * Texas Instruments TMP102 Prefix: 'tmp102' - Addresses scanned: I2C 0x48 0x49 0x4a 0x4b + Addresses scanned: none Datasheet: http://focus.ti.com/docs/prod/folders/print/tmp102.html Author:
@@ -15,13 +15,12 @@ Description The Texas Instruments TMP102 implements one temperature sensor. Limits can be set through the Overtemperature Shutdown register and Hysteresis register. The -sensor is accurate to 0.5 degrees over the range of -25 to +85 C, and to 1.0 -degrees from -40 to +125 C. Resolution of the sensor is 0.0625 degree. The +sensor is accurate to 0.5 degree over the range of -25 to +85 C, and to 1.0 +degree from -40 to +125 C. Resolution of the sensor is 0.0625 degree. The operating temperature has a minimum of -55 C and a maximum of +150 C. The TMP102 has a programmable update rate that can select between 8, 4, 1, and 0.5 Hz. (Currently the driver only supports the default of 4 Hz). The driver provides the common sysfs-interface for temperatures (see -/Documentation/hwmon/sysfs-interface under Temperatures). - +Documentation/hwmon/sysfs-interface under Temperatures).
drivers/hwmon/Kconfig +1 -1
@@ -834,7 +834,7 @@ config SENSORS_THMC50 will be called thmc50. config SENSORS_TMP102 - tristate "Texas Instruments TMP102 and compatibles" + tristate "Texas Instruments TMP102" depends on I2C && EXPERIMENTAL help If you say yes here you get support for Texas Instruments TMP102
drivers/hwmon/tmp102.c +34 -35
159 lines not on this page · raw message
Signature · 6 lines
Jean Delvare _______________________________________________ lm-sensors mailing list [email protected] http://lists.lm-sensors.org/mailman/listinfo/lm-sensors