Skip to contentSkip to conversation

Does U-Boot support BCM5880 board ?

U-Boot Fernand LONE SANG 2 participants 3 messages Jun 1, 2010

lore
Share & tools
lore
#0 lore raw

Hi,

Do you know if the BCM5880 chip is supported by u-boot ? If yes, where is located the code associated to this board ?

According to the output of this
(http://www.codesourcery.com/archives/arm-gnu/msg01069.html)
compilation error, u-boot had some code for the bcm5880. I downloaded the lastest sources from git and did a grep and find through all files but i did not find any code related to the chip.

I am looking for some low level code to probe and pilot that chip. Do you have any hints for me?

Regards,

Fernand

#1 lore raw

Dear Fernand LONE SANG,

Quoted 3 lines · In message <[email protected]> you wrote:

Do you know if the BCM5880 chip is supported by u-boot ? If yes, where is located the code associated to this board ?

Did you try asking Broadcom? Since you seem to be using this chip you might have some channel to place such a question; don't expect too much as a mere mortal, though - nor don't expect that they contribute any of their work back to the community.

Best regards,

Wolfgang Denk

Signature · 5 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Q:  How many DEC repairman does it take to fix a flat ?
A:  Five; four to hold the car up and one to swap tires.
#2 lore raw
Quoted 4 lines

Did you try asking Broadcom? Since you seem to be using this chip you might have some channel to place such a question; don't expect too much as a mere mortal, though - nor don't expect that they contribute any of their work back to the community.

I tried but i did not get any answer from them. That is why i am googling for open source project that already worked with this chip. The muscle (smartcard support project for linux) project also use this chip. I should digg there also for some information.

Regards,

Fernand