Skip to contentSkip to conversation

loongson: enable rtc on rtc-cmos compatibles systems.

PATCH Applied [email protected] 2 participants 3 messages Jun 2, 2010 MIPS

lore
Share & tools
lore
#0 lore raw

cover loongson: enable rtc on rtc-cmos compatibles systems.

Hi,

Now that the rtc-cmos patch has been merged, one can use the rtc-cmos driver on loongson systems with mc146818 compatible rtc.

Arnaud

#1 lore raw

PATCH 1/1 Loongson: define rtc device on mc146818 compatible systems

This patch declare the rtc device present on systems with clock compatible with the mc146818 and handled by rtc-cmos. I've introduced a new Kconfig entry because there are some systems without rtc-cmos compatible clock.

---

 arch/mips/loongson/Kconfig         |    8 	8 +	0 -	0 !
 arch/mips/loongson/common/Makefile |    1 	1 +	0 -	0 !
 arch/mips/loongson/common/rtc.c    |   43 	43 +	0 -	0 !
 3 files changed, 52 insertions(+)
arch/mips/loongson/common/Makefile +1 -0
Index: linux-2.6/arch/mips/loongson/common/Makefile
===================================================================
@@ -12,6 +12,7 @@ obj-$(CONFIG_GENERIC_GPIO) += gpio.o
 obj-$(CONFIG_EARLY_PRINTK) += early_printk.o
 obj-$(CONFIG_SERIAL_8250) += serial.o
 obj-$(CONFIG_LOONGSON_UART_BASE) += uart_base.o
+obj-$(CONFIG_LOONGSON_MC146818) += rtc.o
 
 #
 # Enable CS5536 Virtual Support Module(VSM) to virtulize the PCI configure
arch/mips/loongson/common/rtc.c new file +43 -0

43 lines not on this page · raw message

arch/mips/loongson/Kconfig +8 -0
Index: linux-2.6/arch/mips/loongson/Kconfig
===================================================================
@@ -23,6 +23,7 @@ config LEMOTE_FULOONG2E
 	select GENERIC_HARDIRQS_NO__DO_IRQ
 	select GENERIC_ISA_DMA_SUPPORT_BROKEN
 	select CPU_HAS_WB
+	select LOONGSON_MC146818
 	help
 	  Lemote Fuloong(2e) mini-PC board based on the Chinese Loongson-2E CPU and
 	  an FPGA northbridge
@@ -51,6 +52,7 @@ config LEMOTE_MACH2F
 	select SYS_SUPPORTS_64BIT_KERNEL
 	select SYS_SUPPORTS_HIGHMEM
 	select SYS_SUPPORTS_LITTLE_ENDIAN
+	select LOONGSON_MC146818
 	help
 	  Lemote Loongson 2F family machines utilize the 2F revision of
 	  Loongson processor and the AMD CS5536 south bridge.
@@ -83,3 +85,9 @@ config LOONGSON_UART_BASE
 	bool
 	default y
 	depends on EARLY_PRINTK || SERIAL_8250
+
+config LOONGSON_MC146818
+	bool
+	default n
+
+
Applied
#2 lore raw

Re: [patch 1/1] Loongson: define rtc device on mc146818 compatible systems

Quoted 3 lines · On Wed, Jun 02, 2010 at 12:39:54AM +0200, [email protected] wrote:

This patch declare the rtc device present on systems with clock compatible with the mc146818 and handled by rtc-cmos. I've introduced a new Kconfig entry because there are some systems without rtc-cmos compatible clock.

Applied, but:

/home/ralf/src/linux/linux-mips/.git/rebase-apply/patch:87: new blank line at EOF. +
warning: 1 line adds whitespace errors.

Empty lines at end of file, bad karma. Also to keep log messages in "git log" under 80 characters, keep posted log messages to at most 76 columns.

Anyway, applied. Thanks for sorting this!

Ralf