Skip to contentSkip to conversation

cciss: make sure we request the performant mode irq

PATCH New Mike Miller 1 participant 1 message Jun 4, 2010

Subsystems (2)
SCSI Block layer
lore
Share & tools
lore

Mike Miller

author
#0 lore raw

PATCH 2/5 cciss: make sure we request the performant mode irq

Patch 2 of 5
cciss: make sure we register the performant mode interrupt Another blunder. Seemed to work because the call to put_controller_into_performant_mode was never called.

From: Mike Miller <[email protected]>

Signed-off-by Mike Miller <[email protected]>
Cc Stephen M. Cameron <[email protected]>, [email protected]
---
 drivers/block/cciss.c |    8 ++++----
 1 files changed, 4 insertions(+), 4 deletions(-)
drivers/block/cciss.c +4 -4
index cdc671c..156ea36 100644
@@ -4483,18 +4483,18 @@ static int __devinit cciss_init_one(struct pci_dev *pdev,
 	/* make sure the board interrupts are off */
 	hba[i]->access.set_intr_mask(hba[i], CCISS_INTR_OFF);
 	if (hba[i]->msi_vector || hba[i]->msix_vector) {
-		if (request_irq(hba[i]->intr[SIMPLE_MODE_INT],
+		if (request_irq(hba[i]->intr[PERF_MODE_INT],
 				do_cciss_msix_intr,
 				IRQF_DISABLED, hba[i]->devname, hba[i])) {
 			printk(KERN_ERR "cciss: Unable to get irq %d for %s\n",
-			       hba[i]->intr[SIMPLE_MODE_INT], hba[i]->devname);
+			       hba[i]->intr[PERF_MODE_INT], hba[i]->devname);
 			goto clean2;
 		}
 	} else {
-		if (request_irq(hba[i]->intr[SIMPLE_MODE_INT], do_cciss_intx,
+		if (request_irq(hba[i]->intr[PERF_MODE_INT], do_cciss_intx,
 				IRQF_DISABLED, hba[i]->devname, hba[i])) {
 			printk(KERN_ERR "cciss: Unable to get irq %d for %s\n",
-			       hba[i]->intr[SIMPLE_MODE_INT], hba[i]->devname);
+			       hba[i]->intr[PERF_MODE_INT], hba[i]->devname);
 			goto clean2;
 		}
 	}